Question: While in User mode, which command would you use in the Cisco CLI to enter Privileged EXEC mode? Group of answer choices admin disable privilege

While in User mode, which command would you use in the Cisco CLI to enter Privileged EXEC mode?
Group of answer choices
admin
disable
privilege
enable

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!

Q:

Cis 145- networking Week 3 hands on project Wout 3. Hands-On Progear (Clyoen 5a. . thaby Build a MAC Address Table in Packet Tracer Estimated time: 1-2 Howrs Resources - Computer with Cisco Packet...

Q:

Cisco Networking Academy Mind Wide Open Lab 1.5.2: Basic Router Configuration Topology Diagram 192.168.1.0/24 192.168.2.0/24 192.168.3.0/24 PC1 Fa0/0 S0/0/0 DCE S0/0/0 Fa0/0 PC2 ----- R1 R2...

Q:

Topology Objectives Part 1: Verify the Default Switch Configuration Part 2: Configure a Basic Switch Configuration Part 3: Configure a MOTD Banner Part 4: Save Configuration Files to NVRAM Part 5:...

Q:

Packet Tracer - Configure Initial Switch Settings Part 1: Verify the Default Switch Configuration Part 2: Configure a Basic Switch Configuration Part 3: Configure a MOTD Banner Part 4: Save...

Q:

Part 1: Verify the Default Switch Configuration Step 1: Enter privileged EXEC mode. You can access all switch commands from privileged EXEC mode. However, because many of the privileged commands...

Q:

CCNA Enterprise Networking and Automation v7 Lab 10.6.13 - Answers should be based on Router 1941 Lab - Research Password Recovery Procedures Objectives Part 1: Research the Configuration Register...

Q:

Instructions Part 1 : Verify the Default Switch Configuration Step 1 : Enter privileged EXEC mode. You can access all switch commands from privileged EXEC mode. However, because many of the...

Q:

1. Enter privileged EXEC mode. Router> enable Router# 2. Enter global configuration mode. Router# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)# 3....

Q:

Go back to Router> 1. Enter privileged EXEC mode. Router>enable Router# 2. Enter global configuration mode. Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z....

Q:

Lab 1: Introduction to Packet Tracer Lab 1: Introduction to Packet Tracer Total Marks= 10 Objectives of this Lab: The goal of this lab is to become familiar with building topologies in Packet Tracer...

Q:

You were hired as an analyst to develop a new information system to automate the payroll transactions in a mid-size organization. The proposed system will contain employees data and interface with...

Q:

Bilal Goldsmith broker has shown him two bonds . Each has a maturity of 5 years , a par value of BD 1,000and a yield to maturity of 14 % . Bond A has a coupon. interest rate of 8 % paid annually Bond...

Q:

12218. The boat can travel with a speed of 16 km>h in still water. The point of destination is located along the dashed line. If the water is moving at 4 km>h, determine the bearing angle u at which...

Q:

Suppose a line segment whose endpoints are C(7,3) and D(11,-5) is reflected over y=-x. What is the y- coordinate of D'? (2 Points)