Write a program that implements a programmable temperature sensor a. The program should use the thermistor to detect a temperature value. bThe schematic for wiring the thermistor is included below: Part I SV ANALOG (AB) THERMISTOR 1ekn GND c. Read the value of the thermistor then convert the raw data into temperature, the output should be printed using the Serial object. i. In your setup function, you need to initialize the serial port using the Serial.beginfunction ii. To print information over the serial port, use the Serial.printand Serial.printinfunctions ii. More information on these functions can be found in the textbook and online d. Wire up an LED to pin 9, as done in lab 0. The brightness of the LED should be set according to the following table: Temperature T