Question: Write an assembly code snippet that clears bit 4 in the output Register ( offset 0 0 4 ) of Port C ( base address

Write an assembly code snippet that clears bit 4 in the output Register (offset 004) of Port C(base address 00440) without changing the other bits in the register:
Write an assembly code snippet that clears bit 4

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!

Q:

can someone solve this Modern workstations typically have memory systems that incorporate two or three levels of caching. Explain why they are designed like this. [4 marks] In order to investigate...

Q:

Here is the link for the manual:...

Q:

Find Table 1 in the STM32L476GT6 Reference manual. What is the base address SYSCFG set of registers? 1. 2. Find the offset address of the RCC_APB2ENR register (Section 8.4.21 in the STM32L476...

Q:

Question 1 of 5 2.0 Points ARM GPIO ports have a data register at the base address ([base] ), and a control register at 4 bytes above the base address ( [base+6x4] ). These ports can act as input or...

Q:

Write an assembly program (ATMega128) that calculates a 4 bit CRC code with a polynomial of x 4 + x + 1 (named CRC-4-ITU). The program should call the first subroutine to read the input from a DIP...

Q:

Write in addressing code for IDE app to program. Not counting pushing and pulling registers to the stack, or the lines of code executed by a subroutine, write the keypad in 2 0 lines of code or less...

Q:

I need to write a report on the below and I am not sure where to start. Kindly assist with report that has aim, procedure, discussion and comparison and conclusion:BCD TO 7 SEGMENT LOOKUP...

Q:

Consider an ARM Cortex-A system (not necessarily a DE1-SoC or DE10-Standard). Select registers and memory cells are initialized with the following values. The following code is executed: After the...

Q:

Problem 2 (30 pt.): Write an assembly code set for NIOS II processor to copy a list of 20 52-bit data at memory location 0x 2F00 to the memory location OxIE00 every 0.01 millisecond by using a timer....

Q:

3. Write C code that enables the clock of SYSCFG, GPIOA and GPIOB ports. Enable corresponding GPIOA pin 0 for input (the joystick center pushbutton) and GPIOB pin 2 for output, push-pull (red LED)....

Q:

Use Laplace Transforms to solve for y only dx + 2x + 3y = 0 dt dy + 2y + 3x = dt 2e subject to x(0) = y(0) = 0.

Q:

There are about two hundred sovereign nations in the world today, but only thirty have signed the Cyber-Crime Convention. Why do you think so many nations governments have been reluctant to be bound...

Q:

The risk that a deposits is q , risk. a ) exchange rate b ) None of these are correct. C ) interest rate d ) credit ( default ) e ) liquidity

Q:

What is the leading coefficient of a third degree polynomial function that has an output of 1,272 when x = of-6, 7i, and -7i? Provide your answer below: 2, and has zeros