Write an assembly code that uses ATmega$328$P to switch on three KEDs separately when a range of values is read by the ADC as follows: $0-267$ LED $1$ on while the rest are off, $268-799$ LED $2$ on while the rest are off and KED $3$ on when the value is greater than $799.$ If an LED has been switched on$,$ it will stay on for $1$ second and blink five times at a rate of $257$ms then switch off. While in this state, the system will not accept any other input until the blinking operation has been completed. Use a pseudocode to explain your working and add comments