Write the complete APT part program to perform the profile milling operation for the partQ$13.$ Write the complete APT part program to perform the profile milling operation for the part

drawing in Figure $2.$ Tooling $=20mm$ diameter end mill with two teeth, cutting speed $=125$

$m\frac{m}{m}in,$ and feed $=0\mathrm{.}10m\frac{m}{?}$ tooth. The part is $10mm$ thick. Use the lower left corner of the part

as the origin in the $x-y$ axis system. The two holes in the part have already been drilled and will be

used for clamping the part during milling. Postprocessor call statement is MACHIN$/$MILL$,01.$

drawing in Figure $2.$ Tooling $=20$ mm diameter end mill with two teeth, cutting speed $=125$

mm$/$min$,$ and feed $=0\mathrm{.}10$ mm$/$tooth$.$ The part is $10$ mm thick. Use the lower left corner of the part

as the origin in the x$-$y axis system. The two holes in the part have already been drilled and will be

used for clamping the part during milling. Postprocessor call statement is MACHIN$/$MILL$,01.$