Question: xx is 58 volt Part I - Analysis & Design Design a buck converter to produce an output voltage of XX volts across a 20
xx is 58 volt
Part I - Analysis & Design Design a buck converter to produce an output voltage of XX volts across a 20 ohm load resistor. The output voltage ripple must not exceed 1 percent. The input dc supply is 200 V. Design for continuous inductor current. Specify the following; a- Duty Ratio b- The switching frequency, C- Values of the inductor and capacitor, d- The peak voltage rating of each device, and e. The rms current in the inductor and capacitor. f- Finally add rc=1ohm in series with the capacitor and calculate the change in the ripple voltage ? Assume ideal components
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
