Question: You are installing Windows on a new computer. Using the RAID controller on the motherboard, you configure three hard disks in a RAID 5 array.
You are installing Windows on a new computer.
Using the RAID controller on the motherboard, you configure three hard disks in a RAID array. You leave the array unpartitioned and unformatted. You edit the BIOS boot order to boot from the optical drive. You insert the installation DVD boot to the disc, and start the installation.
When you are prompted to select the disk where you want to install Windows, the RAID array you created does not show as a possible destination disk.
What should you do
###answer###
On the screen where you select the disk to install Windows, click Drive options advanced
Reboot the computer. In the BIOS, change the SATA disk mode to RAID.
Restart the installation and choose Repair your computer. Open a Command Prompt and run Fixmbr and Fixboot.
On the screen where you select the disk to install Windows, click Load Driver.
Step by Step Solution
There are 3 Steps involved in it
1 Expert Approved Answer
Step: 1 Unlock
Question Has Been Solved by an Expert!
Get step-by-step solutions from verified subject matter experts
Step: 2 Unlock
Step: 3 Unlock
