Question: In Figure 4.40, a mixture is heated and expanded before entering a distillation column. Calculate, using a process simulator, mole percent vapor and vapor and

In Figure 4.40, a mixture is heated and expanded before entering a distillation column. Calculate, using a process simulator, mole percent vapor and vapor and liquid mole fractions at locations indicated by pressure specifications.

100 lbmol/h 150F, 260 psia Heater 260F, 250 psia Steam Component C2

100 lbmol/h 150F, 260 psia Heater 260F, 250 psia Steam Component C2 C3 nC4 nC5 nC6 Figure 4.40 Conditions for Exercise 4.40. Valve Mole fraction 0.03 0.20 0.37 0.35 0.05 1.00 100 psia To distillation column

Step by Step Solution

★★★★★

3.32 Rating (179 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Answer Based on Figure 440 the mixture is composed of 50 mol of component A and 50 mol of component ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Separation Process Principles Chemical Questions!

As shown in Figure, a hydrocarbon mixture is heated and expanded before entering a distillation column. Calculate, using a simulation computer program, the mole percent vapor phase and vapor and...

A pipe flow 0.15 lb mol a second mixture with mole fractions of 40% CO2 and 60% N2 at 60 lbf/in 2, 540 R. Heating tape is wrapped around a section of pipe with insulation added and 2 Btu/s electrical...

A natural gas mixture consists of 90.0 mole percent CH4 (methane) and 10.0 mole percent C2H6 (ethane). Suppose water is saturated with the gas mixture at 20C and 1.00 atm total pressure, and the gas...

Can you please help me with this : For the HDA Process 1. Calculate the amount of heat required in E-101 to preheat the feed stream mixture (Stream B) from your previously calculated temperature...

For the HDA Process 1. Calculate the amount of heat required in E-101 to preheat the feed stream mixture (Stream B) from your previously calculated temperature (say, -46C) to 225C. Here you need to...

first picture shows question! i am so confused! pleaee help ASAP! the rest of the photos are all the additional experiment info i have Report your results including: a. (2 points) volume collected...

Unisim Assignment Reactor Steam Phare Separator Othe Ful Problem Statement You are going to use is to simulate a steady state process to make 150.000 tom of dry ethanol per year from ethylene...

Can you draww the flowchart question 4 and question 5 ? Question 5 (20 pts). A steady state process consisting of an absorption tower and a stripping tower is used to separate the components of a gas...

Question 5 of 9 0.25/1 Attempts: 1 of 10 used Benzene Recovery in Overhead Use the constraint on benzene recovery in the overhead to solve for the total overhead flow (ni (mol)). ni = i mol Attempts:...

1. An effective system of internal control will segregate functions between individuals to reduce the potential for errors and fraud. True False 2. When one individual is responsible for all of the...

In fiscal 2011, RONA lost almost $75 million whereas in 2010 it made almost $143 million. Analyze RONA's income statements, Note 5.1, and any other information you think is relevant in Exhibit 12.4...

A loan with the following terms is being made: Fixed rate, constant monthly payment. Five percent interest rate. $ 7 0 , 0 0 0 mortgage loan amount. $ 1 , 5 0 0 loan discount points to be paid by the...

KEY QUESTION Complete the following table: a. Show the consumption and saving schedules graphically. b. Find the break-even level of income. Explain how it is possible for households to dissave at...

A number of techniques can separate proteins on the basis of their differences in mass. Describe the use of two of these techniques, centrifugation and gel electrophoresis. The blood proteins...

Chromatography is an analytical method used to separate proteins. Describe the principles for separating proteins by gel filtration, ion-exchange, and affinity chromatography.

Various methods have been developed for detecting proteins. Describe how radioisotopes and autoradiography can be used for labeling and detecting proteins. How does Western blotting detect proteins?

A bicycle manufacturer currently produces 268,000 units a year and expects output levels to remain steady in the future. It buys chains from an outside supplier at a price of $ 1.90 a chain. The...

The Bandon Pine Corporation's purchases from suppliers in a quarter are equal to 6 5 percent of the next quarter's forecast sales. The payables period is 6 0 days. Wages, taxes, and other expenses...

Topic: Currency Options Adam buys a put option on curos (contract size is 625.000) at a premium of $0.02/. The strike price is $1.2018 (a) If the spot price of the euro at the date of expiration is...