Question: Use the portal method and determine (approximately) the reactions at supports A,B,C, and D. K 9 kN 4 m F 12 kN 4 m D

Use the portal method and determine (approximately) the reactions at supports A,B,C, and D.

K 9 kN 4 m F Н 12 kN 4 m D - 5 m- 5 m -

K 9 kN 4 m F 12 kN 4 m D - 5 m- 5 m -

Step by Step Solution

★★★★★

3.33 Rating (162 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

9 KN 150 KN Oy 300 KN 300KN 9 KN 150 KN 12 KN Saf Ty 350KN 700 KN 700 ... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Document Format (2 attachments)

PDF file Icon

1589_60619c5aeb76e_676001.pdf

180 KBs PDF File

Word file Icon

1589_60619c5aeb76e_676001.docx

120 KBs Word File

Students Have Also Explored These Related Structural Analysis Questions!

Q:

Use the portal method and determine (approximately) the reactions at A. 3k 15 ft D 4 k 15 ft E 18 ft- -20 ft-

Q:

Draw the moment diagram for girder IJKL of the building frame. Use the portal method of analysis. K 20 kN 4 m G 40 kN E 4m 5 m 4 m 24 (10-3) m 16 (10-) m 16 (10-) m 24 (10-3) m Area

Q:

Use the portal method of analysis and draw the 1 moment diagram for girder FED. 15 kN 6 m E8 mH-8 m-

Q:

Problem 4 : ( 2 0 points ) Use the portal method and determine ( approximately ) the reactions at supports A , B , C , and D . Plot the approximate moment diagram for beam EFGH. Sketch every FBD...

Q:

i. Use the portal method and determine (approximately) the reactions at supports A, B, and C. 10 kN I H G 15 m 20 kN D E F A 18m 18m B -20 m 15 m C

Q:

Draw (approximately) the moment diagram for the girder \(E F G H\). Use the portal method. 36 kN E F G H 10 m. B 8m+ C -12 m- 8 m D

Q:

A continuous beam as shown in Figure Q1 has fixed support at A and pinned supports at B, C and D. The beam is subjected to a point load of 5 kN at point E, a uniformly distributed load of 6 KN/m...

Q:

Please show complete solution Solve by using moment area method for the indeterminate beams The load acting on the beam ABC has a triangular distribution. Find the reactions at all three supports. El...

Q:

16:14 LTE BA Assignment_6 1. Company Z is a battery producer. They operate 8 hours per day and need to produce 300 units per day next month in order to compensate the forecasted demand that will...

Q:

ENGG 202 - Engineering Statics - Winter 2023 SCHULICH Worksheet 7 - Truss Analysis selection. e) Select a joint that you would like to start with to determine the members forces. Justify your Answer:...

Q:

Determine the normal force, shear force, and moment in the beam at sections passing through points D and E. Point E is just to the right of the F load. Units Used: kip = 103 lb Given: a = 6 ft w =...

Q:

During a panel interview at Joy FM, Henrietta who happened to be one of the interviewees was asked "You studied Telecommunication and Information Networking right? as it is rightly indicated on your...

Q:

Volume based cost accounting systems often do not provide sufficiency

Q:

Complete the proof of Theorem 11.2.8 by considering n even.

Q:

The shaft of diameter b is held in the hole such that the normal pressure acting around the shaft varies linearly with its depth as shown. Determine the frictional torque that must be overcome to...

Q:

Because of wearing at the edges, the pivot bearing is subjected to a conical pressure distribution at its surface of contact. Determine the torque M required to overcome friction and turn the shaft,...

Q:

The conical bearing is subjected to a constant pressure distribution at its surface of contact. If the coefficient of static friction is s, determine the torque M required to overcome friction if the...

Q:

Find the following values. Compounding/discounting occurs annually. Do not round Intermediate calculations. Round your answers to the nearest cent. a. An initial $200 compounded for 10 years at 10%....

Q:

DISCUSS QUESTION #4 Apollo Inc paid a dividend last year of $1.50. Dividends are expected to grow at a rate of 17% this year, 15% next year, 10% the following year and 5% thereafter. The required...

Q:

You have had a 15yr FA FRM at 7% for 6 years. The original principal was $500,000. You are considering a cash-out refi into a 30-year mortgage at 5%. The old mortgage has no prepay penalty. The new...