Question: With reference to the sketch, verify the cable bolting formula below. If the formula is unsatisfactory, then derive a substitute formula based on a dead
With reference to the sketch, verify the cable bolting formula below. If the formula is unsatisfactory, then derive a substitute formula based on a dead weight load analysis. Here S = spacing (ft, m) assuming a square pattern, N = number of cables per hole, U = ultimate tensile strength (tons, kN), V = specific volume of the rock mass (ft3/ton, m3/kN), T = thickness of suspended rock mass (ft, m), ? =bolting angle from the horizontal, SF = bolt safety factor. Note: this formula appeared in the technical literature some years ago.

NUV T(SF) sin a Vein HW FW Fill
Step by Step Solution
3.41 Rating (170 Votes )
There are 3 Steps involved in it
Given Find Identify terms derive Handout S spacing N number in a hole U tensile stren... View full answer
Get step-by-step solutions from verified subject matter experts
Document Format (1 attachment)
26-E-G-R (309).docx
120 KBs Word File
