Question: (x = 16.5 MPa, (y = - 91 MPa, Txy = - 39 MPa (a) Determine the principal stresses and show them on a sketch

(x = 16.5 MPa, (y = - 91 MPa, Txy = - 39 MPa
(a) Determine the principal stresses and show them on a sketch of a properly oriented element.
(b) Determine the maximum shear stresses and associated normal stresses and show them on a sketch of a properly oriented element?

Step by Step Solution

★★★★★

3.50 Rating (170 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

a Principal Stresse... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

836-P-M-S (644).docx

120 KBs Word File

Students Have Also Explored These Related Mechanics Questions!

A propeller shaft subjected to combined torsion and axial thrust is designed to resist a shear stress of 56 MPa and a compressive stress of 85 MPa (see figure). (a) Determine the principal stresses...

(x = 2500 psi, (y = 1020 psi, Txy = - 900 psi (a) Determine the principal stresses and show them on a sketch of a properly oriented element. (b) Determine the maximum shear stresses and associated...

(x = 2150 kPa, (y = 375 kPa, Txy = - 460 kPa (a) Determine the principal stresses and show them on a sketch of a properly oriented element. (b) Determine the maximum shear stresses and associated...

(x = - 108 MPa, (y = 58 MPa, Txy = - 58 MPa (a) Determine the principal stresses and show them on a sketch of a properly oriented element. (b) Determine the maximum shear stresses and associated...

An element in pure shear is subjected to stresses Txy = - 14.5 MPa, as shown in the figure. Using Mohr's circle, determine: (a) The stresses acting on an element oriented at a counterclockwise angle...

(x = 33 MPa, (y = - 9 MPa, Txy = 29 MPa, ( = 35 Using Mohr's circle, determine the stresses acting on an element oriented at an angle ( from the x axis. Show these stresses on a sketch of an element...

(x = - 47 MPa, (y = - 186 MPa, Txy = - 29 MPa, ( = - 33 Using Mohr's circle, determine the stresses acting on an element oriented at an angle ( from the x axis. Show these stresses on a sketch of an...

(x = 27 MPa, (y = 14 MPa, Txy = 6 MPa, ( = 40° Using Mohr's circle, determine the stresses acting on an element oriented at an angle ( from the x axis. Show these stresses on a sketch of an...

(x = - 29.5 MPa, (y = 29.5 MPa, Txy = 27 MPa Using Mohr's circle, determine (a) the principal stresses and (b) the maximum shear stresses and associated normal stresses. Show all results on sketches...

(x = 0 MPa, (y = 23.4 MPa, Txy = - 9.6 MPa Using Mohr's circle, determine (a) the principal stresses and (b) the maximum shear stresses and associated normal stresses. Show all results on sketches of...

In an oscillating LC circuit, L = 4.26 mH and C = 2.18 F. At t = 0 the charge on the capacitor is zero and the current is 1.60 A. (a) What is the maximum charge that will appear on the capacitor? (b)...

Why should a ground wire be connected to the metal support rod for a television antenna?

Find the limit of the rational function ( a ) as xo and ( b ) as x - co . Write co or - co where appropriate . 8 x 7 + 2 x 6 + 5 = 3 x 8

70. Refer to the following box plot: a. Estimate the median. b. Estimate the first and third quartiles. c. Determine the interquartile range. d. Beyond what point is a value considered an outlier? e....

The assembly consists of three titanium (Ti-6A1-4V) rods and a rigid bar AC. The cross-sectional area of each rod is given in the figure. If a force of 6 kip is applied to the ring F, determine the...

19. The load of 800 lb is supported by the four 304 stainless steel wires that are connected to the rigid members AB and DC. Determine the angle of tilt of each member after the load is applied. The...

The rigid bar is supported by the pin-connected rod CB that has a cross-sectional area of 500 mm2 and is made of A-36 steel. Determine the vertical displacement of the bar at B when the load is...

Use below code as reference / skeleton . Try not to deviate from the windows x 8 6 paradigms. Write a program to ask the user to enter number less than 5 . If the user enters greater than 5 , the...

Choose a stock that interests you. Utilizing Bloomberg, Yahoo Finance, or Google Finance, etc. as a source of data, collect the following information: a. The stock's Beta b. Use the lyr market risk...

The 6-month, 12-month, 18-month, and 24-month zero rates are 3.00%, 3.50%, 4.00%, and 4.50% with semi-annual compounding. Q1: What are the rates with continuous compounding? Q2: What is the forward...