Question: A current density of 0.05 A/cm2 is applied to a 150 cm2 cathode. What period of time is required to plate out a 1-mm-thick coating

A current density of 0.05 A/cm2 is applied to a 150 cm2 cathode. What period of time is required to plate out a 1-mm-thick coating of silver onto the cathode?

Step by Step Solution

★★★★★

3.55 Rating (165 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

The current in the cell is I iA 005 A cm 2 150 cm 2 75 A T... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

814-P-M-S (1461).docx

120 KBs Word File

Students Have Also Explored These Related Mechanics Questions!

A current density of 0.1 A/cm2 is applied to the iron in an iron-zinc corrosion cell. Calculate the weight loss of zinc per hour (a) If the zinc has a surface area of 10 cm2 and the iron has a...

A 1-m-square steel plate is coated on both sides with a 0.005-cm-thick layer of zinc. A current density of 0.02 A/cm2 is applied to the plate in an aqueous solution. Assuming that the zinc corrodes...

A corrosion cell is composed of a 300 cm2 copper sheet and a 20 cm2 iron sheet, with a current density of 0.6 A/cm2 applied to the copper. Which material is the anode? What is the rate of loss of...

Hi! I need a bit oh help solving this multi-part question, thanks in advance! Question 6: Q6A: Cu2+ is dissolved in water to make a half cell that will produce an electrode potential of +0.23 V....

1 2 3 4 5 6 7 8 9 10 11 12 13 14 teacher asked me to make a word document and give an explanation below each picture. Since I am not a good writer, could someone please help me to write a brief...

Determine the galvanic corrosion rate in aerated 3% NaCl of the anode in a couple between equal areas of (a) carbon steel (iron) and 316 stainless steel and (b) between equal areas of 316 stainless...

PXT992 Research Project Plan Degradation Mechanisms in Quantum Dot on Silicon Lasers Author 1 Purpose (motivation) One of the most urgent issues in semiconductor technology is the direct development...

I need a Gantt chart or similar timetable briefly outlining what & when you will be doing, and more description on the process you will be following to complete these tasks. E.g. Pre-degradation...

1. Consider Figure 3.4. This was produced using equation 3.9. Using Excel, MATLAB or a similar mathematical program, reproduce this diagram for yourself. (The main problem will be the case where the...

.... Thanks.! 14-77. An article in the Textile Research Institute Journal 876 76- 726 719 (1984. Vol. 54. pp. 171-179) reported the results of an experi- 945 ment that studied the effects of treating...

See Figure 11-19 and draw the cooling curves, including appropriate temperatures, expected for the following Al-Si alloys. (a) Al-4% Si; (b) Al-12.6% Si; (c) Al-25% Si; and (d) Al-65% Si.

State three reasons why multiple t tests cannot be used to compare three or more means.

Dorrentakempt in Progress Irventory information for Part 3 1 1 of Crane Corp discloses the following information for the month of June: \ table [ [ Jure 1 , Balance, 4 4 0 units $$ 1 , June 1 0 ,...

1 What is marginal cost? How is it measured?

The assembly shown in the figure consists of a brass core (diameter d1 = 0.25 in.) surrounded by a steel shell (inner diameter d2 = 0.28 in., outer diameter d3 = 0.35 in.). A load P compresses the...

A nonprismatic bar ABC is composed of two segments: AB of length L1 and cross-sectional area A1; and BC of length L2 and cross-sectional area A2. The modulus of elasticity E, mass density p, and...

A bimetallic bar (or composite bar) of square cross section with dimensions 2b Ã 2b is constructed of two different metals having moduli of elasticity E1 and E2 (see figure). The two parts of...

include financial calculator steps 21. One bank offers you 5% interest compounded semi-annually. What is the equivalent rate if interest is compounded quarterly

As a result of loan write-offs, Bank A has to be liquidated by the regulators. The book value of the assets and liabilities of the bank is presented below (in millions of dollars). The market value...

Question 8 Events A and B are independent, P(A) = P(B) and P(A U B) = 0.63. Find P(B). Give an approximate answer as a decimal rounded to three significant figures