Question: A manometer is mounted on a city water-supply pipe to monitor water pressure, as shown in Figure P2.4.5. However, the manometer reading of 3 ft

A manometer is mounted on a city water-supply pipe to monitor water pressure, as shown in Figure P2.4.5. However, the manometer reading of 3 ft (Hg) may be incorrect. If the pressure in the pipe is measured independently and found to be 16.8 lb/in.2 (psi), determine the correct value of the reading h.

2 ft H20 Hg Figure P2.4.5

Step by Step Solution

★★★★★

3.44 Rating (170 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

A surface of equal pressure can be drawn at the ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

884-P-M-F-M (662).docx

120 KBs Word File

Students Have Also Explored These Related Mechanics Questions!

A plexiglass tube (piezometer) is mounted on a pipe as shown in Figure P9.2.1. Another plexiglass tube with a 90° bend (i.e., Pitot tube) is inserted into the center of the pipe and directed...

A mercury (sp. gr. = 13.6) manometer is used to measure water pressure in a pipe. Referring to Figure 2.5 (a), the value of y is 3.40 cm and the value of his 2.60 cm. Determine the pressure in the...

A vertical piston/cylinder has a linear spring mounted. The spring is mounted so at zero cylinder volume a balancing pressure inside is 100 kPa. The cylinder contains 0.5 kg of water at 125C,...

QUESTION 3 1 Points A manometer is mounted on a city water - supply pipe to monitor water pressure, as shown in Figure. If the pressure in the pipe is measured indenpently and found to be P 1 lb / in...

SYSTEM The compressor in a conveying line system is pushing dry air at 2.2 atm gauge pressure into the system. You can get the average viscosity of the air as 1x10 Pas. The air pressed into the...

A mercury manometer is used to measure the pressure drop across an orifice that is mounted in a vertical pipe. A liquid with a density of $0.87 \mathrm{~g} / \mathrm{cm}^{3}$ is flowing upward...

An orifice meter (see Figure 3.2-1) is to be calibrated for the measurement of the flow rate of a stream of liquid acetone. The differential manometer fluid has a specific gravity of 1.10. The...

i need only answer A simple U-manometer is mounted in a flow system. The manometer is filled with mercur (relative density 13.6) and above the mercury is a liquid with a relative density of 1.6....

Q1/ An orifice meter is to be calibrated for the measurement of the flow rate of a stream of liquid acetone. The differential manometer fluid has a specific gravity of 1.10. The calibration is...

A sphere and a circular cylinder (with its axis perpendicular to the flow) are mounted in the same free stream. A pressure tap exists at the top of the sphere, and this is connected via a tube to one...

How have P&C industry product lines based on net premiums written by insurance companies changed over time?

There is a soil whose properties are: It is requested to determine the width "B" of the square footing: Determine B using a numerical method such as Newton Raphson or another numerical method. C=...

Assumed data for Samsung and Apple follow. $ millionsSamsungAppleContribution margin$ 7 4 , 6 1 2 $ 1 3 8 , 1 4 0 Income 1 8 , 6 5 3 5 5 , 2 5 6 Required: Compute the degree of operating leverage for...

List some examples of good teams and of poor teams.

The hydrometer shown in figure is a device for measuring the density of liquids. The bulb contains lead shot, and the density can be read directly from the liquid level on the stem after the...

Water flows at 0.65 m/s through a hose with a diameter of 3cm. The diameter of the nozzle is 0.30 cm. (a) At what speed does the water pass through the nozzle? (b) If the pump at one end of the hose...

Water is flowing at 3 m/s in a horizontal pipe under a pressure of 200 kPa. The pipe narrows to half its original diameter. (a) What is the speed of flow in the narrow section? (b) What is the...

Calculating the Cost of Equity Smaltz Enterprises is currently involved in its annual review of the firms cost of capital. Historically, the firm has relied on the CAPM to estimate its cost of equity...

You run a construction firm. You have just won a contract to build a government office building. It will take one year to construct it requiring an investment of 9.79 million today and 5.0 million in...