Question: A sphere and a circular cylinder (with its axis perpendicular to the flow) are mounted in the same free stream. A pressure tap exists at

A sphere and a circular cylinder (with its axis perpendicular to the flow) are mounted in the same free stream. A pressure tap exists at the top of the sphere, and this is connected via a tube to one side of a manometer. The other side of the manometer is connected to a pressure tap on the surface of the cylinder. This tap is located on the cylindrical surface such that no deflection of the manometer fluid takes place. Calculate the location of this tap.

Step by Step Solution

★★★★★

3.33 Rating (171 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

For the sphere For the cylinder At the top of the sphere T2 he... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

12-E-A-E-A (60).docx

120 KBs Word File

Students Have Also Explored These Related Aerospace Engineering Questions!

A solid cylinder with its axis horizontal sits completely submerged in a fluid on the bottom of a tank. Compute the force exerted by the cylinder on the bottom of the tank for the following data: D =...

A wheel is rotating about an axis perpendicular to the plane of the wheel and passing through the center of the wheel. The angular speed of the wheel is increasing at a constant rate. Point A is on...

A Venturi tube may be used as a fluid flow meter (see Fig. 14.20). If the difference in pressure is P1 P2 = 21.0 kPa, find the fluid flow rate in cubic meters per second, given that the radius of the...

An irrotational region of two-dimensional flow is formed by superimposing a source of strength m 1 = 2.00 m 2 /s at (x,y) = (0, 1), a sink of strength m 2 = 1.00 m 2 /s at (x,y) = (1, 1), and a...

Initials: Problem 1 - 25 points A Bobsled challenge requires that the competitors clear a vertical circular loop of radius R, after starting at the same height as the top of the loop. You may assume...

Initials: Problem 5 - 25 points The device shown in the figure is used to measure fluid speeds. The two coaxial tubes are designed such that the inner tube has a small opening at point 1, which is...

Any part of the question complete would be helpful. I will give an amazing review, thanks!! Initials: Problem 2 - 25 points A thin rod of mass M, and length L is mounted on a frictionless vertical...

806 Chapter Fifteen OPTIMIZATION: LOCAL AND GLOBAL EXTREMA If f is not continuous or the region R is not closed and bounded, there is no guarantee that f achieves a global maximum or global minimum...

Are earmarks a good way or a bad way to make policy? If Congress were to allow earmarks again, would pairing earmarks with an expedited rescission process result in an improved policymaking process?...

Describe the surface. x2 - y2 = 1 answer hyperbolic cylinder, I need help with the rest [0/0.69 Points] DETAILS PREVIOUS ANSWERS SCALCET9 12.XP.6.003. MY NOTES ASK YOUR TEACHER PRACTICE Describe the...

Sanjida is annoyed. She has been informed by her supervisor that from now on, she will be getting feedback reports on the quality and quantity of her output, and that she will be directly responsible...

Using the data in Question 17, what are (a) The total cost of work in process and (b) The cost of goods manufactured?

The price of bread increases by 50 percent. As a result, quantity demanded for cheese falls 20 percent. The cross-price elasticity of demand for bread and cheese is (A) 0.4 (B) 0.4 (C) 2.5 (D) 2.5...

The answers are given, but i need help with solving them. thanks 9. In the setup below, the current through the 910-ohm resistor is 0.0056A. Determine the power dissipated by the bulb. Ans:0.00036W...

How many sums and products should be done to find a sum of this kind: a;b; i=1 j=1

A helium balloon has a flexible skin of negligible weight and infinite capacity for expansion, so that the helium is always at the same pressure as the surrounding air. If the balloon moves up and...

For the drying oil process shown in Appendix B, check the design specifications for the following three pieces of equipment against the appropriate heuristics: V-501, P-501, H-501. Comment on any...

For the conditions of Prob. 12.1, calculate the pressures (in the form of p/p) on the top and bottom surfaces of the flat plate, using linearized theory. Compare these approximate results with those...

Consider a diamond-wedge airfoil such as shown in Figure 9.24, with a half-angle = 10. The airfoil is at an angle of attack = 15 to a Mach 3 free stream. Using linear theory, calculate the lift and...

Consider a subsonic compressible flow in Cartesian coordinates where the velocity potential is given by If the free stream properties are given by V? = 700 ft/s, p? = 1atm, and T? = 519R, calculate...

Using the Prandtl-Glauert rule, calculate the lift coefficient for an NACA 2412 airfoil at 5 angle of attack in a Mach 0.6 free stream. (Refer to Fig. 4.5 for the original airfoil data.)

In low-speed incompressible flow, the peak pressure coefficient (at the minimum pressure point) on an NACA 0012 airfoil is 0.41. Estimate the critical Mach number for this airfoil, using the...

Help ASAP According to a report, 40% of millennials have a BA degree. Suppose we take a random sample of 800 millennials and find the proportion who have a BA degree. Find the probability that at...