Question: A plane wall 20 cm thick with uniform internal heat generation of 200 kW/m3 is exposed to a convection environment on both sides at 50C

A plane wall 20 cm thick with uniform internal heat generation of 200 kW/m3 is exposed to a convection environment on both sides at 50ºC with h = 400 W/m2 · ºC. Calculate the center temperature of the wall for k = 20 W/m ∙ ºC.

Step by Step Solution

★★★★★

3.48 Rating (187 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

2L 20cm 02m q2L 2x105... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

892-P-T-H-T (645).docx

120 KBs Word File

Students Have Also Explored These Related Thermodynamics Questions!

Experiments have been performed on the temperature distribution in a homogeneous long cylinder (0.1 m diameter, thermal conductivity of 0.2 W/(m K) with uniform internal heat generation. By...

Uniform internal heat generation at q = 5 X 107 W/m3 is occurring in a cylindrical nuclear reactor fuel rod of 50-mm diameter, and under steady-state conditions the temperature distribution is of the...

The shield of a nuclear reactor can be idealized by a large 10 in. thick flat plate having a thermal conductivity of 2 Btu/(h ft ?F). Radiation from the interior of the reactor penetrates the shield...

A plane wall 2 0 cm thick with uniform internal heat generation of 2 0 0 kW / m 3 is exposedtoaconvectionenvironmentonbothsidesat 5 0 Cwithh = 4 0 0 W / m 2 C . Calculate the center temperature of...

A plane wall 15 cm thick has a thermal conductivity given by the relationk = 2.0 + 0.0005 T W/(m K)where T is in degrees Kelvin. If one surface of this wall is maintained at 150 ?C and the other at...

To prepare for problems 5.79 and 5.80 use the Internet or other resources and define the following terms in the context of rocket propulsion: (a) Solid fuel, (b) Grain, (c) Surface regression. Also,...

A plane wall 7.5 cm thick, generates heat internally at the rate of 105 W/m3. One side of the wall is insulated, and the other side is exposed to an environment at 90?C. The convective heat transfer...

A cylindrical-port rocket motor has a grain design consisting of a cylindrical shape as shown. The curved internal surface and both ends burn. The solid propellant surface regresses uniformly at 1...

Reconsider the fin design from Design Problem 2.1, but calculate the natural-convection heat transfer coefficient from information presented in this chapter. As shown in the schematic diagram, the...

A plane wall 6.0 cm thick generates heat internally at the rate of 0.3 MW/m3. One side of the wall is insulated, and the other side is exposed to an environment at 93C. The convection heat-transfer...

A leader must understand how leadership theories can be used to influence and reward individuals and teams, and develop interpersonal skills that build trust. In your paper, address the following:...

Cerenkov radiation the Russian physicist P A Cerenkov discovered that a charged particle traveling in a solid with a speed exceeding the speed of light in that material radiates electromagnetic...

Only anlayse the code in red please Assume the 5 - stage pipeline machine support 2 - read ports and 1 write - port. Assume there is no implicit bypass forwarding of execution result to register...

Which of the following is NOT a valid output of the verify scope process? A. Accepted deliverables B. Work performance measurements C. Change requests D. Project document updates

A light oil flows through a copper tube of 2.6 cm ID and 3.2 cm OD. Air is flowing over the exterior of the tube. The convection heat transfer coefficient for the oil is 120 W/(m2 K) and for the air...

Repeat Problem 8.3, but assume that fouling factor of 0.0009 (m2 K)/W on the inside and 0.0004 (m2 K)/W on the outside respectively have developed.From Problem 8.3: A light oil flows through a copper...

Water flowing in a long aluminum tube is to be heated by air flowing perpendicular to the exterior of the tube. The ID of the tube is 1.85 cm and its OD is 2.3 cm. The mass flow rate of the water...

QUESTION 2 2 points Saspares Agricultural Cooperative has current liabilities of S162,500, net working capital of 28,560, investory of $175.800, and sales of 51.941.140 What is thick atio? For the...

Annual labor assumptions for full-time employees Position Number Avg. Salary Base Salary Benefit Ralse Date Raise % Physician 12 $200,000 $2,400,000 25% Feb-02 4.5% Physician 11 8 $220,000 $1,760,000...

1. Ahmed insures himself with AXA insurance company. His contract includes a straight deductible of 50BD. During the year he suffers multiple losses: first loss 200 and second loss 500. Based on this...