Question: A steam power plant has a steam generator exit at 4 MPa, 500C and a condenser exit temperature of 45C. Assume all components are ideal

A steam power plant has a steam generator exit at 4 MPa, 500°C and a condenser exit temperature of 45°C. Assume all components are ideal and find the cycle efficiency and the specific work and heat transfer in the components.

Step by Step Solution

★★★★★

3.42 Rating (158 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

From the Rankine cycle we have the states 1 45C x v 1 00... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

774-P-T-F-L (1366).docx

120 KBs Word File

Students Have Also Explored These Related Thermodynamics Questions!

A steam power plant has high and low pressures of 25 MPa and 10 kPa, and one open feedwater heater operating at 1 MPa with the exit as saturated liquid. The maximum temperature is 800C and the...

A small steam power plant has a boiler exit of 3 MPa, 400C while it maintains 50 kPa in the condenser. All the components are ideal except the turbine which has an isentropic efficiency of 80% and it...

A steam power plant has a steam generator exit at 4 MPa, 500C and a condenser exit temperature of 45C. Assume all components are ideal and find the cycle efficiency and the specific work and heat...

A steam power plant operates with a high pressure of 5 MPa and has a boiler exit temperature of 600 C receiving heat from a 700 C source. The ambient at 20 C provides cooling for the condenser so it...

For the previous problem, also find the specific entropy generation in the boiler heat source setup. Data from previous problem A steam power plant operates with a high pressure of 4 MPa and has a...

A steam power plant operates with a high pressure of 4 MPa and has a boiler exit of 600C receiving heat from a 750Csource. The ambient at 20Cprovides cooling to maintain the condenser at 60C. All...

A steam power plant operates between a boiler pressure of 1 5 MPa and a condenser pressure of 5 0 kPa . Calculate the maximum cycle efficiency and draw the cycle on the Ts diagram. ( 6 marks ) Now,...

4. A steam power plant operates between a boiler pressure of 42 bar and a condenser pressure of 0.035 bar according to a Rankine cycle with reheat. At the boiler exit, the steady-flow of steam at 4...

Question # 1 : In an ideal reversible non - regenerative steam cycle the initial steam pressure and temperature are 1 5 0 bar and 5 0 0 C respectively, and the condenser pressure is 0 . 0 4 bar. If...

A company's accounts payable department has identified that a supplier has overcharged them for a certain product. The company was charged $200 per unit of the product, whereas the fair market price...

The members of a truss are pin connected at joint O. Determine the magnitudes of F 1 and F 2 for equilibrium. Set u = 60?. 5 kN 70 30 7 kN

In January 2 0 2 0 , three - month ( 9 1 - day ) Treasury bills were selling at a discount of 1 . 7 4 % . What was the annual yield? Assume 3 6 5 days in a year. Note: Do not round intermediate...

Refer to Exercise 11, a. Find a 90% upper confidence interval for the mean lifetime. b. Someone says that the mean lifetime is less than 1220 hours. With what level of confidence can this statement...

In a local bar, a customer slides an empty beer mug down the counter for a refill. The bartender is momentarily distracted and does not see the mug, which slides off the counter and strikes the floor...

The four particles in Figure P10.21 are connected by rigid rods of negligible mass. The origin is at the center of the rectangle. If the system rotates in the xy plane about the z axis with an...

Two balls with masses M and m are connected by a rigid rod of length L and negligible mass as in Figure P10.22. For an axis perpendicular to the rod, show that the system has the minimum moment of...

3. There is a semi-batch reactor with 100 L X solution at a concentration of 2 mol/L. Inert solution (I) at a concentration of 0.5 mol/L is sent to this reactor at a rate of 0.75 L/min. Reaction...

Please answer the questions Show all images Show all images Show all images done loading

1) Find the value of the grand mean glucose content, SSA and MSA. 2) Find SSW and MSW. 3) At the 5% level, test whether the glucose content is affected by by the type of carbohydrate. Five groups,...