Question: For a 50 m diameter turbine in a 30 mph wind, determine (a) The mass flow rate of air (in kg/s) intercepted by the turbine.

For a 50 m diameter turbine in a 30 mph wind, determine
(a) The mass flow rate of air (in kg/s) intercepted by the turbine.
(b) The specific kinetic energy (ke) of the flow (in kJ/kg),
(c) The rate of transport of kinetic energy kW.
(d) The maximum possible shaft power. Assume density of air as 1.1 kg/m3 and use Betz's law.
(e) What-if Scenario: What will be the maximum shaft power if the wind velocity drops to 15 m/s?
For Information: Problem 1-1-37 [KP].

Step by Step Solution

★★★★★

3.41 Rating (160 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

a b c d W sh 053... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

861-ME-T (6775).docx

120 KBs Word File

Students Have Also Explored These Related Mechanical Engineering Questions!

Betz's law states that only 53% of the kinetic energy transported by wind can be converted to shaft work by a perfect wind turbine. For a 50 m diameter turbine in a 20 mph wind, what is the maximum...

A small dam has a pipe carrying liquid water at 150 kPa, 20C with a flow rate of 2000 kg/s in a 0.5 m diameter pipe. The pipe runs to the bottom of the dam 15 m lower into a turbine with pipe...

A small dam has a pipe carrying liquid water at 150 kPa, 20C with a flow rate of 2000 kg/s in a 0.5 m diameter pipe. The pipe runs to the bottom of the dam 15 m lower into a turbine with pipe...

MEM553 Problem Based Learning/ Complex Eingineering Problem GROUP ASSIGNMENT Commence Date: 4 rd Jan 2023 Dateline: 27ih Jan 2023 (Before 5 pm) Course Outcomes This assignment is established to...

A gas turbine system operates with air entering at a velocity of 115 m/s and a density of 1.25 kg/m. The gas turbine inlet area is 0.05 m. Air leaves the turbine at a velocity of 135 m/s and a...

Rankine cycle I is Turbine A Rankine cycle is shown aside. This cycle is used to generate power with water as the working fluid. It consists of four unit processes in a thermodynamic cycle: a...

8-61 Steam enters a diffuser at 10 kPa and 50C with a velocity of 300 m/s and exits as saturated vapor at 50C and 70 m/s. The exit area of the diffuser is 3 m. Determine (a) the mass flow rate of the...

PLEASE ANSWER QUESTIONS FROM 1-6 AS ALL ARE A PART OF ONE QUESTION. From atmosphere To atmosphere To help with the analysis follow the steps below, 1. For the industrial waste heat power plant,...

Republic of Iraq Ministry of Higher Education and Scientific Research University of Technology Chemical Engineering Department MODELING AND SIMULATION OF FCC RISERS A RESEARCH SUBMITTED TO THE...

What effect will a subsidiary's 15 percent stock dividend have on the elimination entries used in preparing a consolidated balance sheet at the end of the year in which the dividend is distributed?

Can accounting manipulations influence earnings-based estimates of company valuation? Explain.

How could this situation have been avoided? In your answer, consider also aspects of motivation and HRP.

Find the first six terms of the recursive sequence. a1 3, an11 s3an

A piston - cylinder device initially contains 0.8 m3 of saturated water vapor at 250 kPa. At this state, the piston is resting on a set of stops, and the mass of the piston is such that a pressure of...

A 40-L electrical radiator containing heating oil is placed in a 50-m3 room. Both the room and the oil in the radiator are initially at 10oC. The radiator with a rating of 2.4 kW is now turned on. At...

Steam at 75 kPa and 8 percent quality is contained in a spring-loaded piston - cylinder device, as shown in Fig. P4 - 39, with an initial volume of 2 m3. Steam is now heated until its volume is 5 m3...

1. Regulation and supervision of the financial system include 3 risk mitigation strategies to balance the safety net, which are: a.Regulation, supervision and enforcement b.Enforcement, supervision...

Baba Company is a manufacturing firm that uses job-order costing. The company's inventory balances were as follows at the beginning and end of the year: Beginning Balance Ending Balance Raw...

Workshop Exercise Variance Analysis Barack Obama Ltd manufactures a single product, Tuxedos. The company uses a standard cost accounting system. From notes scattered on the desk of the cost...