Question: Phosphoric acid is usually obtained as an 85% phosphoric acid solution. If it is 15 M, what is the density of this solution? What is

Phosphoric acid is usually obtained as an 85% phosphoric acid solution. If it is 15 M, what is the density of this solution? What is its molality?

Step by Step Solution

★★★★★

3.46 Rating (172 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

Assume there is 1000 L of the solution which will contain 15 mol H 3 PO 4 molar ... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Document Format (1 attachment)

Word file Icon

806-C-P-c-P-O-S (233).docx

120 KBs Word File

Students Have Also Explored These Related Physical Chemistry Questions!

Q:

Helping Harvest is a food bank in the Greater Miami area that collects food donations from local grocery stores and transports them back to a distribution center for sorting and transfer to local...

Q:

a. Calculate K1 at 25C for phosphoric acid: b. Which thermodynamic factor is the most significant in accounting for the fact that phosphoric acid is a weak acid? Why? H3PO4(aq)--H"(aq) + H,PO4-(aq)...

Q:

The root-mean-square speed of the molecules of an ideal gas at 25oC and a pressure of 2.50 atm is 5.00 102 m/s. What is the density of this gas?

Q:

One hundred fifty k mol of an aqueous phosphoric acid solution contains 5.00 mole% H3PO4. The solution is concentrated by adding pure phosphoric acid at a rate of 20.0 L/min. (a) Write a differential...

Q:

Phosphoric acid is usually obtained as a 85\% phosphoric acid solution. If it is 15.00M, what is the density of this solution? What is its molality? Density=Molality=g/mLm

Q:

Hydrochloric acid is usually obtained as a 36% hydrochloric acid solution. If it is 13.42M, what is the density of this solution? What is its molality? Density =g/mL Molality =m

Q:

Hydrochloric acid is usually obtained as a 36% hydrochloric acld solution. If it is 13.42M, what is the density of this solution? What is its molality? Density=Molality=g/mLm

Q:

A concentrated aqueous solution of phosphoric acid has a density of 1.69 g/mL. If the solution is 85.5% by mass H3POs, what is the concentration of phosphoric acid (mol/L or M) in this solution? A...

Q:

the central science of chemistry The automobile fuel called E85E85 consists of 85%% ethanol and 15%% gasoline. E85 can be used in the so-called flex-fuel vehicles (FFVs), which can use gasoline,...

Q:

Hydrochloric adid is usually obtained as a 36% hydrochloric acid solution. If it is 13.42.M, what is the density of this solution? What is its molality? Density=g/mL.Molality=m 10 item attempts...

Q:

A solution contains 26% phosphoric acid by mass. This means that 1mL of this solution contains 26g of phosphoric acid the density of this solution is 2.6g/mL 100g of this solution contains 26g of...

Q:

As shown in Fig. P1.38, an underwater exploration vehicle submerges to a depth of 1000 ft. if the atmospheric pressure at the surface is 1 atm, the water density is 62.4 lb/ft3, and g = 32.2ft/s2,...

Q:

The cross-section of a steel specimen measures 1 in. by 0.5 in. When tested in tension, it yielded at a load of 38 kips, and then finally failed at a load of 50 kips. Setting Youngs Modulus equal to...

Q:

The tone of your voice, rate of speech, and how you deliver your message are relatively unimportant in the impression management area. True Feter

Q:

so here is the situation my teacher gona ask question on this image but l dont know what is gona ask its probly about conversion of mechanical energy so could you guys give imaginery numbers and...

Q:

Provide IUPAC names for the following compounds and, where applicable, include RIS or EIZ designation to indicate the stereochemistry. (4 marks) i) ii) ii) Br iv) NO2

Q:

The following molecule allows three rotation angles per bond (two bonds). Each bond rotation angle is independent and can exist in 3 states; high energy (2 kl/mol), middle energy (1 kJ/mol), and low...

Q:

Find Ker A, Row A, Col A, and Ker AT when A is the matrix below. 2 1 (a) 2 1 -1 (b) 2 0 (c) -1 0 0 11

Q:

For the following robot diagram: a) Draw the orthonomal coordinate system attached to each link according to DH notation. b) Write the DH parameters in the given table and write the values of joint...

Q:

How do we calculate the payback period for a proposed capital budgeting project? What are the main criticisms of the payback method?

Q:

If a constant [Cl] = 0.100 M is maintained in a solution in which the initial [Pb 2+ ] = 0.065 M, what percentage of the Pb 2+ will remain in solution after PbCl 2 (s) precipitates? What [Cl] should...

Q:

Which of the following would be most effective, and which would be least effective, in reducing the concentration of the complex ion [Zn(NH 3 ) 4 ] 2+ in a solution: HCl, NH 3 , or NH 4 Cl? Explain...

Q:

In a solution that is 0.0500 M in [Cu(CN) 4 ] 3- and 0.80 M in free CN - , the concentration of Cu + is 6.1 x 10 -32 M. Calculate K f of [Cu(CN) 4 ] 3- . Cut (aq) + 4CN (aq) [Cu(CN)4](aq) K = ?

Q:

Question 50 1 Imagine a sample with n = 49 and a mean of 95 that comes from a population with a standard deviation of 14. Based on these data, what would be the 80% confidence interval for the...

Q:

The Landers Corporation needs to raise $1.70 million of debt on a 20-year issue. If it places the bonds privately, the interest rate will be 12 percent. 25000 dollars in out-of-pocket costs will be...

Q:

a comparable - risk bond is 6 percent. a . Compute the bond's yield to maturity. b . Determine the value of the bond to you given the market's required yield to maturity on a comparable - risk bond....