Consider the system of blocks in Figure P4.64, with m 2 = 5.0 kg and =
Question:
Consider the system of blocks in Figure P4.64, with m2= 5.0 kg and θ = 35°. If the coefficient of static friction between block 1 and the inclined plane is µS= 0.25, what is the largest mass m1for which the blocks will remain at rest?
Figure P4.64
m2 тy
Step by Step Answer:
Use Newtons first law the equation for static friction and apply transnational equilibrium Draw a fr...View the full answer
College Physics Reasoning and Relationships
ISBN: 978-0840058195
2nd edition
Authors: Nicholas Giordano
Related Video
Static friction and kinetic friction are two types of friction that occur when two objects are in contact with each other. Static friction is the force that must be overcome to initiate motion between two surfaces that are in contact with each other but are not moving relative to each other. It is caused by the interlocking of rough surfaces at the microscopic level, and it increases as the force pushing the surfaces together increases. Once motion between the surfaces starts, the static friction is no longer present. Kinetic friction, also known as sliding friction, is the force that opposes the motion of two surfaces that are in contact with each other and are moving relative to each other. It is caused by the rubbing of the surfaces against each other and the resistance of the molecules in the surfaces to being moved. Kinetic friction is generally less than static friction, but it can still be a significant force, especially at high speeds. Both static and kinetic friction can be quantified using a coefficient of friction, which is a dimensionless number that represents the ratio of the frictional force between two surfaces to the normal force (the force perpendicular to the surfaces). The coefficient of static friction is typically greater than the coefficient of kinetic friction for a given pair of surfaces, because it takes more force to overcome the interlocking of the surfaces at rest than to maintain motion once it has started.
Students also viewed these Sciences questions
-
Consider the system of Problem 4.54. The interior surface is exposed to hot gases at 350C with a convection coefficient of 100 W/m2 K, while the exterior surface experiences convection with air at...
-
Consider the system of Figure, with the discrete-time system an ideal lowpass filter with cutoff frequency ?/8 radians/s.? (a) If x c (t) is bandlimited to 5 kHz, what is the maximum value of T that...
-
Consider the system of pulleys shown in Fig. The string (which is a loop with no ends) hangs over N fixed pulleys. N masses, m1, m2, ., mN, are attached to N pulleys that hang on the string. What are...
-
The following is information for Palmer Company. \ table [ [ , Year,Year 2 , Year 1 ] , [ Cost of goods sold,$ 6 3 3 , 8 2 5 , $ 4 1 6 , 6 5 0 , $ 3 8 1 , 3 0 0 The following is information for...
-
As the controller of Best Security Systems, you have hired a new bookkeeper, whom you must train. She objects to making an adjusting entry for accrued salaries at the end of the period. She reasons,...
-
Honey Enterprises had the following investing activities: Cash paid to purchase land $107166 Cash received from sale of building $553715 Cash paid to purchase equipment $27429 Determine the Cash...
-
The calculation of solar radiation impinging on a surface is of importance in many applications, for example, design of solar collectors, temperature control of buildings, etc. Your goal is to review...
-
What will be the nominal rate of return on a preferred stock with a $100 par value, a stated dividend of 8 percent of par, and a current market price of? (a) $60, (b) $80, (c) $100, and (d) $140?
-
Assume a 100 2 chip working at 1 GHz and = 1, with an average activity factor of = 0.1. It uses a standard cell process with an average switching capacitance of 500 /2. a) (5 points) Estimate the...
-
The Stockholders' Equity section of the balance sheet for Cooperstown Corp. at the end of 2017 appears as follows: 8%, $100 par, cumulative preferred stock, 200,000 shares authorized, 50,000 shares...
-
A water skier (Fig. P4.65) of mass m = 65 kg is pulled behind a boat at a constant speed of 25 mi/h. If the tension in the horizontal rope is 1000 N (approximately 225 lb), what are the magnitude and...
-
What is the approximate magnitude of the drag force on an airplane (such as a commercial jet) traveling at 250 m/s? Consider only the drag force on the fuselage of the airplane (and not on the wings).
-
Simtz Company is preparing its opening IFRS statement of financial position on January 1, 2012. Under its previous GAAP, Smitz did not record a prevision for litigation in the amount of 85,000 that...
-
1. Draw a Chart of relationship between SMM and CPR, starting from SMM = 0.1% to 10%, with step size of 0.1%. What conclusions can you make form the chart? (0.5 points) 2. Convert SMM to CPR and PSA...
-
Mr Filou has invested Rs 1 000 000 on the first of January 2005 in the following units managed by the Penny Investment Associates: Table 1: Mr Filou's portfolio Benchmarks Correlation of the...
-
Graph the NPV of the following cashflows using discount rates between 0 and 250% (by 10%). How many IRRs can you identify? Use Excel's IRR function and the Guess option to identify the IRRs. Under...
-
During a tensile test of a steel material, a flat specimen with an initial gage length 50 mm and a width of 12 mm is used. Yield strength and tensile strength are determined as 340 MPa and 420 MPa,...
-
Choose two of the employee business letters List Examples to analyze. Part 1: Either print and annotate by hand or electronically annotate the letter using Adobe Acrobat, Apple Preview, or other...
-
It has been estimated that 40% of all U.S. children are covered by life insurance. For a randomly selected group of 10 children, use the appropriate statistical table to describe the probability...
-
Using a graphing utility, graph y = cot -1 x.
-
For each of the compounds below, locate the pattern we just learned (lone pair next to a Ï bond) and draw the appropriate resonance structure: a. b. c. d. e. f. g. h. NH2
-
Draw the resonance structure(s) for each of the compounds below: a. b. c. d.
-
The formalism of the Youngs modulus is sometimes used to calculate the reversible work involved in extending or compressing an elastic material. Assume a force F is applied to an elastic rod of...
-
Reflecting on the book Who Gets Promoted, Who Doesn't, and Why (Asher, 2008), answer the following questions in depth. Explain the statement, "all business is sales." What six things matter? If...
-
Reflecting on the book Who Gets Promoted, Who Doesn't, and Why (Asher, 2008), answer the following questions in depth. No matter what you have done in the past, the boss really doesn't care. Why?...
-
Do you think Richard Scrushy should have been found guilty or acquitted for his role in the case against HealthSouth? https://www.wsj.com/articles/SB111702610398942860
Study smarter with the SolutionInn App