Question: For these problems, the table holds various binary values for register $t0. Given the value of $t0, you will be asked to evaluate the outcome
For these problems, the table holds various binary values for register $t0. Given the value of $t0, you will be asked to evaluate the outcome of different branches.
Suppose the program counter (PC) is set to 0x2000 0000. Is it possible to use the jump (j) MIPS assembly instruction to get set the PC to the address as shown in the data table above? Is it possible to use the branch-on-equal (beq) MIPS assembly instruction to set the PC to the address as shown in the data table above? Note the format of the J-type instruction.
a. 0x00101000 b. 0x80001000
Step by Step Solution
3.55 Rating (159 Votes )
There are 3 Steps involved in it
In MIPS assembly the j jump instruction is used to change the value of the program counter PC to an absolute address It uses a 6bit opcode field follo... View full answer
Get step-by-step solutions from verified subject matter experts
