Question: A cylindrical container whose weight is 65 N is inverted and pressed into the water, as shown in Fig. P3169. Determine the differential height h

A cylindrical container whose weight is 65 N is inverted and pressed into the water, as shown in Fig. P3–169. Determine the differential height h of the manometer and the force F needed to hold the container at the position shown.

F Air D = 25 cm 20 cm Manometer fluid SG =

F Air D = 25 cm 20 cm Manometer fluid SG = 2.1 Water

Step by Step Solution

★★★★★

3.31 Rating (166 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Differential height h of the manometer The differential height h of the manometer is the difference in height between the two columns of manometer fluid This height difference is due to the pressure d... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Fluid Mechanics Questions!

Determine the force in each cable and the force F needed to hold the lamp of mass M in the position shown. Hint: First analyze the equilibrium at B; then, using the result for the force in BC,...

Suppose that there is a cylindrical container whose height is 10 meters and whose base radius is 1 meter. The bottom of the container has a hole, through which water leaks out at a rate (in meter...

As shown in fig 1.7, a manometer is attached to a tank of gas in which the pressure is 104.0 kPa. The manometer liquid is mercury, with a density of 13.59 g/cm3. If g = 9.81 m/s2 and the atmospheric...

A cylindrical container whose weight is 8 0 N is inverted and pressed into the water, as shown below. Determine the force F needed to hold the container at the position shown and the height h in the...

5 . A cylindrical container is inverted and pressed into the water, as shown in the figure. If the specific gravity of the manometer fluid is 2 . 1 Determine the differential height h of the...

To warm up some milk for a baby, a mother pours milk into a thin-walled cylindrical container whose diameter is 6 cm. The height of the milk in the container is 7 cm. She then places the container...

A cylindrical container whose height and diameter are 8 m is filled with a mixture of CO 2 and N 2 gases at 600 K and 1 atm. The partial pressure of CO 2 in the mixture is 0.15 atm. If the walls are...

Repeat Prob. 13101 by replacing CO 2 by the H 2 O gas. Data from problem 101 A cylindrical container whose height and diameter are 8 m is filled with a mixture of CO 2 and N 2 gases at 600 K and 1...

Sugar juice is filtering through a conical funnel 2 0 cm deep and 1 2 m across at the top, into a cylindrical container whose diameter is 1 0 cm . When the depth of the juice in the funnel is 1 0 cm...

A glass has 3 immiscible liquids. The densities and volume of each of these are known. They. It is known that they are deposited in a cylindrical container whose diameter is 1 ft. Determine the...

Name three ways in which the service industry differs from the manufacturing industry.

1. What was the plaintiffs claim in the intermediate appellate court? 2. What was the appellate courts decision? 3. What rationale did the court give for its decision? Lifson, J. The underlying facts...

Evaluate each of the following without using a calculator. (a) 256 (b) $1024 64 64 (c) (d) 125 729

2. Discuss your position on one cruise line dominating the industry, such as Carnival.

Consider a 6-m-diameter spherical gate holding a body of water whose height is equal to the diameter of the gate. Atmospheric pressure acts on both sides of the gate. The vertical component of the...

Consider a 6-m-diameter spherical gate holding a body of water whose height is equal to the diameter of the gate. Atmospheric pressure acts on both sides of the gate. The horizontal component of the...

A 2-m-long and 3-m-wide horizontal rectangular plate is submerged in water. The distance of the top surface from the free surface is 5 m. The atmospheric pressure is 95 kPa. Considering atmospheric...

An exempt organization can be organized as which of the following businesses entities

fo. d

Complete the following table for each scenario. Complete the following table for each scenario