Question: Consider a very long rectangular fin attached to a flat surface such that the temperature at the end of the fin is essentially that of

Consider a very long rectangular fin attached to a flat surface such that the temperature at the end of the fin is essentially that of the surrounding air, i.e., 20°C. Its width is 5.0 cm; thickness is 1.0 mm; thermal conductivity is 200 W/m·K; and base temperature is 40°C. The heat transfer coefficient is 20 W/m²·K. Estimate the fin temperature at a distance of 5.0 cm from the base and the rate of heat loss from the entire fin.

Step by Step Solution

★★★★★

3.36 Rating (168 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

A very long fin is attached to a flat surface The fin temperature at a certain d... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Fundamentals Thermal Fluid Questions!

Consider a very long, very thin plastic rod as sketched in Figure P17.60. Assume the rod has length L = 1.0 ? 10 6 m and a total charge of 1.0 C distributed evenly along the rod. Your job in this...

Use the step-by-step approach in Problem 60 to find the electric field produced by the hollow metal cylinder with charge per unit length = 1.0 10 -6 C/m in Figure P17.61. Be sure to find the...

A cantilever beam AB of length L and height h (see figure) is subjected to a temperature change such that the temperature at the top is T1 and at the bottom is T2. Determine the equation of the...

1 ) Consider a very long rectangular fin attached to a flat surface such that the temperature at the end of the fin is essentially that of the surrounding air, i . e . , \ ( 2 0 ^ { \ circ } \ mathrm...

1 WILMINGTON UNIVERSITY LIBRARY Business Continuity Plan (BCP) and Disaster Recovery Plan (DRP) 2 WILMU LIBRARY SERVICES 20,000 student population served 13 physical locations of access to university...

Please quality check my solutions for this advanced heat transfer problem. Show all work. Thank you. All original documents are located at the bottom. 3.9 COMPACT HEAT EXCHANGERS 3.9.10-1 3.9.10...

What is the general equation for H T through an extended surface? What is the solution of that equation if the extended surface is very long and the temperature at the end of the extended surface is...

The electronic controls of a medical imaging device are housed in a compartment such that it heat dissipates heat to the ambient from a flat vertical plate surface, 15 cm wide and 20 cm high, to...

Please evaluate the quality of the design (answer questions within 1-4 on the gas turbine recuperator rating problem). Please answer all questions asked. Show all calculations. I have provided...

2. One-dimensional heat transfer in a straight fin (see sketch below) is governed by the following heat equation d2T - + c2T + c3 = 0 dX2 C1 = = with C1 = kA, C2 = -hp, C3 = hpTwhere A denotes the...

Taha Company Ltd. is required to prepare a cash budget for the quarter. a. On July 1, the beginning of the third quarter, the company will have a cash balance of $200,000. b. Actual sales for the...

(a) What is the resistance of a lightbulb that uses an average power of 75.0 W when connected to a 60.0-Hz power source having a maximum voltage of 170 V? (b) What If? What is the resistance of a...

ob 910 was recently completed. The following data have been recorded on its job cost sheet: Direct materials $ 2,461 Direct labor-hours 74 labor-hours Direct labor wage rate $ 18 per labor-hour...

2. The company is successful in at least some of the major markets (global marketing is usually not a crisis solution).

Using the relation (S) = 1/2 Re{E s Ã H s } and Eqs. (106) through (108), show that the average power density in the TE10 mode in a rectangular waveguide is given by

Integrate the result of Problem 13.22 over the guide cross section, 0

Show that the group dispersion parameter, d 2 Î²/dÏ 2 , for a given mode in a parallel-plate or rectangular waveguide is given by where Ï c is the radian cutoff frequency for the...

The dividend yield on Alpha's common stock is 5.2 percent. The company just paid a $2.10 dividend. The rumor is that the dividend will be $2.30 next year. The dividend growth rate is expected to...

A call option has an exercise price of $50. What is the value of the call option at expiration if the stock price is $35? $75? A put option has an exercise price of $30. What is the value of the put...

Mergers, Acquisitions, and Other Restructuring Activities 8th Edition By Donald DePamphilis Chapter 10 Problem 15 (Practice Problems and Answers) 10.15 PPA You have been asked by an investor to value...