Question: Water flows through a circular pipe having a constriction in diameter from 1 in. to 0.5 in. The velocity of the water just upstream of

Water flows through a circular pipe having a constriction in diameter from 1 in. to 0.5 in. The velocity of the water just upstream of the constriction is 4 ft/s. By using the result of Problem P6.35, determine:

(a) The velocity of the water downstream from it.

(b) The pressure drop across the constriction.

Step by Step Solution

★★★★★

3.39 Rating (165 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Because river slope generally decreases in a downstream dir... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Introduction Mechanical Engineering Questions!

Water flows through a 20-cm commercial steel pipe at 20C. The flow rate is 80 liters per second, and pressure is constant throughout the length of the pipe. Determine the slope of the pipe. Assume...

Water flows through a variable-area pipe with a mass flow rate of 10,000 kg/min. Determine the minimum diameter of the pipe if the flow velocity is not to exceed 5 m/s. Assume density () of water to...

Water flows through a circular nozzle, exits into the air as a jet, and strikes a plate. The force required to hold the plate steady is 70 N. Assuming frictionless one-dimensional flow, estimate (a)...

Question 5 (20 points): Water flows through a horizontal pipe at 1.1 fi/sec as shown in figure 4. Determine the pipe diameter of section B if the non-dimensional roughness is E/D = 0.03. Recall that...

1. The capillary rise of water in the glass tube is mathematically given by 20Cost using D. 2pgr par B. Par 20cost par Cose 2. is an instrument used to measure the difference between two points in a...

Computer science Problem 1 : Thermodynamics - Gas Power Cycle A gas turbine power plant operates on an ideal Brayton cycle with regeneration. The pressure ratio across the compressor is 1 0 . Air...

ATTEMPT ALL QUESTIONS. BE SURE TO ANSWER A body with mass m = 1 2 kg is attached to the end of a spring that is stretched 2 m by a force of 100 N. Furthermore, there is also attached a dashpot4 that...

5-180 Determine the power input for a compressor that compresses helium from 150 kPa and 20C to 400 kPa and 200C. Helium enters this compressor through a 0.1-m2 pipe at a velocity of 15 m/s. 5-181...

i need help with the calculations, excel data provided. thank you Calculations: Using the relationship given, obtain the friction factor for each pipe, calculate Re for each flow rate and plotf vs...

University of Hartford Department of Civil, Environmental and Biomedical Engineering CE 320 Water Resources Engineering Spring Semester 2017 Lab #5 - Pump Performance Characteristics Report Outline...

eg: Determine tthe number of iterations to Solve fox) x+4x-10 with accuracy 3 3 using a, =1 and b, = 2.

A dash pot 15 cm diameter and 25 cm long slides vertically down in a cylinder having 16 cm diameter with a uniform velocity. The oil filling the annular space has a viscosity of 0.7 poise. Find the...

14 The area of this compound shape is 15 m. The area of one rectangle is 94m. a estimate, then b calculate the area of the other rectangle.

3. Develop a risk analysis scenario using the Risks of Radical Redesign framework discussed in the chapter.

A single stage compressor is required to compress $94 \mathrm{~m}^{3}$ air per min from 1 bar and $25^{\circ} \mathrm{C}$ to 9 bar. Find the temperature at the end of compression, work done, the...

An ideal gas is heated from $25^{\circ} \mathrm{C}$ to $145^{\circ} \mathrm{C}$. The mass of the gas is $2 \mathrm{~kg}$. Determine: (i) specific heats, (ii) change in internal energy, (iii)...

Define the following terms: (i) Absolute pressure and Atmospheric pressure. (ii) Enthalpy and Energy.

III. PROBLEM 24. (8 points) Here is the DuPont info on HCSH and its industry. ROE = NPM X TATO XEQUITY MULTIPLIER DU PONT (CORRIGAN): 14%= 3% X 2 X 2.33 DU PONT (INDUSTRY); 18%= 3.1% X 2.47 x 2.35...

PART TWO Problem Solving Questions Question 1(7 points) Within the context of the capital asset pricing model (CAPM), assume that expected return on the market is 14%, the risk-free rate is 6%, the...

40% of people that enter Starbucks spend $3, 25% spend $5, and the rest of people don't spend anything at all. Let X be the amount that a random customer spends at Starbucks. Calculate the average...