Question: 04-B) A liquid-level system, such as the one shown in the below figure, has a cross-sectional area of 3.0 At?. The valve characteristics are q=812

04-B) A liquid-level system, such as the one shown in the

04-B) A liquid-level system, such as the one shown in the below figure, has a cross-sectional area of 3.0 At?. The valve characteristics are q=812 where q=flow rate, cfm, and l-level above the valve, ft. Calculate the transfer function and time constant for this system if the average operating level above the valve is 9 ft q, f3/min 9o, ft/min h (0) Op. ft/min 9.872 2 ft

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

1. Exercise (Deriving the Transfer function of Nonlinear System) A nonlinear liquid-level system, such as the one shown in the figure 1, has a cross-sectional area of 3.0 m. The valve characteristic...

Consider the liquid level control system shown in the diagram below. Height h of liquid Water (constant density) in the tank (cross-sectional area A=0.25m2 ) is detected by the transmitter (LT) and...

prob.5.3 5.3. A tank having a cross-sectional area of 2ft2 is operating at steady state with an inlet flow rate of :( 2.0cfm. The flow-head characteristics are shown FIGURE P5-3 (a) Find the transfer...

University of Hartford Department of Civil, Environmental and Biomedical Engineering CE 320 Water Resources Engineering Spring Semester 2017 Lab #5 - Pump Performance Characteristics Report Outline...

a. Example 13-1: Batch Reactor with an Exothermic Reaction Wolfram 1. Adiabatic Case: Use Wolfram to see whether you can find a trajectory that is ready to ignite and whose trajectory looks like a...

RE S E ARCH AR T I C L E The Lack of Motor Vehicle Occupant Restraint Use in Children Arriving at School KATHRYN D. EMERY, MDa S. GLENN FARIES, MDb ABSTRACT BACKGROUND: Motor vehicle crashes are the...

A schematic of the key components of a supersonic, blowdown wind tunnel is shown in Fig. 1. Compare this against Fig. 5.9 of Liepmann and Roshko which features a continuous wind tunnel. Continuous...

Consider the hot water delivery system shown in the figure for a 5 storey bulding. Water at 5 0 oC is pumped using the pump placed after the boiler shown. Each floor should receive water at a flow...

A report consisting of 700 words Make a short introduction, where you explain (in your own words) what balanced management is as well as how balanced management is used by Norwegian municipalities....

Reference FOSSUM. (2008). Labor Relations, 10th Edition. [VitalSource Bookshelf version]. Retrieved from http://online.vitalsource.com/books/1259220389/epubcfi/6/34 Page 294 Chapter Ten Nonwage...

Which factor makes the differentiator circuit unstable? Output impedance Input voltage Noise Gain

Find the Y parameters for the two-port network shown .

What is beta, and how does it measure stock risk

Question 22 5 Points Dijkstra's algorithm is executed at node x, this will generate the forwarding table that router x will use to forward the received packets to any destination in the topology. 5...

6. Explain the roles of monetary policy and fiscal policy in causing and ending hyperinflations.

3. Other things equal, an increase in the world interest rate pushes the trade balance toward and causes the currency to . a. surplus, appreciate b. surplus, depreciate c. deficit, appreciate d....

6. If the demand for real money balances depends on the nominal interest rate, then higher inflation can a. increase the quantity of real money balances. b. reduce the nominal interest rate. c....