Question: 1 . Find the frequency response ( amplitude and phase response ) of a system whose transfer function is H ( s ) = 2

1. Find the frequency response (amplitude and phase response) of a system whose transfer function is H(s)=2 s +2. Also, find the system response y(t) if the input x(t) is (a) cos(2t)(1 pts)(b) cos(5t 28)(1 pts)

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

2. Find the frequency response H (61\") of a discrete-time stable system whose input n] and output y[n] satisfy the following difference equation: y[n] gym 1] = $[n] -l- 2x[n 1] + :c[n - 2] Then...

Q:

+ VR(t)- Vi(t) Figure 1. RL circuit Simulink-Matlab: use Simulink to Construct the circuit of Figure 1, using R 100 Ohms and L 1mH Use your oscilloscope to measure both VIN (t) and R(t) In order to...

Q:

A motor mounted at the midpoint of a massless fixed - fixed beam, as illustrated in Figure 1 , experiences a rotating unbalance that generates a sinusoidal force with an amplitude of 2 0 0 N at 6 0...

Q:

D. Plot of Frequency Response Create superimposed plots of the magnitude of the transfer function versus frequency for the lter in Fig. 1 under two conditions: I) With ideal component values. 2) With...

Q:

a) Given a system whose transfer function (TF) is the following one, G(s) = 10 s (1+0.1.s) Using straight line approximations, draw a Bode diagram (magnitude and phase plots) for the range of angular...

Q:

-0.03963 2. The stirred-tanker heater tank-temperature system has transfer function between T inlet temperature T and the thermocouple temperature is T 0.2025 + 1 If the inlet temperature is varied...

Q:

Problem 1 Find the amplitude period frequency and phase shift of the function whose graph is given below if the point a f a is and the point b f b is UI a f a b f b If we call the period P what is...

Q:

Process Control- Design, Analysis and Assessment MCQ 4) For a process with only time delay term. 1 point the frequency response shows 1) Controller parameters for the system 1 point 2e 25 G(S) = (103...

Q:

# 4 ( 5 0 points ) The experimental open - loop frequency response plots for a system are shown. Approximate the transfer function that corresponds to the frequency response plots. Write it as a...

Q:

A. For the system whose transfer function is given by: g(s)=(2s+1)(5s+1)(3s+1)1 and whose step response is given by: y(t)=(1+35et/238et/5)2 Show from this step-response expression that this is an...

Q:

An individual's genetic makeup is determined by the genes obtained from each parent. For every genetic trait, each parent possesses a gene pair, and each parent contributes one-half of this gene...

Q:

Predict the mononitration products of the following aromatic compounds. Circle the answer please! A) m-nitrochlorobenzene B) m-nitroanisole C) o-methylacetanilide

Q:

Assume a company has a payout ratio of 4 8 percent, a profit margin of 5 percent, a cost of equity of 1 5 percent and a growth rate of 2 . 0 percent. Do not round intermediate calculations. Round...

Q:

a. Was the engagement team's assessment of the evaluation of the design of each control appropriate (i.e., does the control identified by the team address the specific risk of material misstatement...