Question: 1 . Water - based Vapor Compression Cycle. Design a vapor compression cycle using water as the refrigerant. This cycle will run between an evaporator

1 .

Water

-

based Vapor Compression Cycle. Design a vapor compression cycle using water as the refrigerant. This cycle will run between an evaporator temperature of

\ (5^{\

circ

} \

mathrm

{

} \)

and a condenser temperature of

\ (35^{\

circ

} \

mathrm

{

} \)

and aim to deliver

1

kW of cooling power. Determine the required mass flow rate, the work consumption, and the COP. Compare your results to a conventional vapor compression cycle based on R

- 134

a and comment on the differences.

1 . Water - based Vapor Compression Cycle. Design

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Principles of Food and Bioprocess Engineering (FS 231) HW #4: 50 points (Due on 04-15-2022) 1. An R-12 vapor compression refrigeration system is to be used to maintain the air in the ice cream...

1. 2000 cfm outdoor air at 95 F/80 "F is mixed with 3000 cfm return air at 75 "F, 40% RH. The mixture of the two air streams enters a cooling coil having a 0.2 bypass factor and a 48 F apparatus dew...

(12 points) A refrigerator using refrigerant-134a as the working fluid operates on the vapor compression cycle. The cycle operates between 200 kPa and 1.2 MPa. The refrigerant flows through the cycle...

A mechanical vapor compression cycle (MVC) is the heart of the HVAC system shown in the figure. A central water chiller at the basement cools the chilled water that gets pumped upward to three air...

Condenser Throttle valve Compressor 1 2 Evaporator A refrigerating system employs the vapor compression cycle, depicted above, with n-butane as the refrigerant. The following are known about this...

how do I choose when to use enthalpy and when to use internal energy to solve an exercise? A promising new idea is to use river water as a heat source for heating buildings. A heat pump is being...

Close - Ended Problem A refrigeration system using R - 2 2 as the refrigerant is to have a refrigerating capacity of 8 0 kW . The cycle is a vapor compression cycle with an evaporating temperature of...

1 (12 points): An ideal vapor compression refrigeration cycle using R-134a, operates with an evaporating temperature of -20 F and condensing temperature of 60 F. The refrigerant leaves the evaporator...

The space is cooled at a constant rate of 1 2 1 kW based on the ideal vapor compression cycle with R 1 3 4 a refrigerant between 1 2 0 and 7 0 0 kPa. Water is used to take the heat of the refrigerant...

One of the expansion device's functions could be as follows: O Guided the refrigeration fluid flow in the evaporator. O Allow the refrigeration fluid flow in the evaporator. O Prevent the...

What are the reasons for the dramatic increase in cross border trade between the United States and Mexico?

Q. Please Draw a diagram of a silicon atom crystal that is dope with a group III element and group V element to illustrate an N-type material and a P-type material.

3 The Home and Garden (HG) chain of superstores imports decorative planters from Italy. Weekly demand for planters averages 1,500 with a standard deviation of 800. Each planter costs $10. HG incurs a...

Basic Scenario 9: Retest Questions Directions Read the scenario information for Hailey Simpson. 2500 25. Hailey must report $ of her gambling winnings on her 2023 return. (Note: whole number only, do...