2. Make a par e G using a power Our ( You can change the resistance by select in table - 2 below. 3. Place the non - contact ammeter at either th current values. 4. Use Ohm's law to calculate the voltage acro 5. Use the voltmeter to confirm the voltage, tip and the threaded section of the bulb. 6. Once you have confirmed the voltage of you each bulb. 7. Finally, take a screen shot or save the ci box "values", so the resistor values show u cir cutiot .create a screenshot on a PC, press computer keyboard, and then paste the capt Mac, then pressing Command - Shift - 3 will ca 8. . Record aTlalb Idea 2a gPrae al below: sistance (ohms) Current Voltage calculated Voltage measured Power (amps) (Volts) (Volts) (Watts)