1 Make a series circuit using a power source ( You can change the resistance by selecting table 1 . 2. Place the non - contact ammeter at either the current values. 3. Use Ohm's law to calculate the voltage acros 4. Use the voltmeter to confirm the voltage, b tip and the threaded section of the bulb. R 5. Once you have confirmed the voltage of your each bulb. 6. Finally , take a screen shot or save the cir box "Values " and have the ammeter and vol t met ( To create a screenshot on a PC, press Alt - keyboard, and then paste the captured i mage pressing Command - Shift - 3 will capture a scr Record alabdet a :gil Seemi beel ow: Table 1: Series Resistance Current Voltage calculated Voltage measured Power (ohms) (amps) (Volts) (Volts) (Watts)