Question: A beam of rectangular cross section, depth 2 5 0 m m , breadth 1 2 m m has a maximum permitted tensile stress of

A beam of rectangular cross section, depth 250mm, breadth 12mm has a
maximum permitted tensile stress of 147.15Nmm2. Calculate the maximum
bending moment to which the beam may be subjected.
[18.39 kNm]
A beam of rectangular cross section, depth 2 5 0

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

3 A beam of rectangular cross section 200 mm deep and 100 mm wide. If the beam is 3m long, simply supported at either end and carries point loads as shown in Figure 3. (a) (b) (c) (d) Im . 5 kN . +...

Q:

Consider a simply supported beam of rectangular cross section of constant width b and variable depth h, so proportioned that the maximum stress x at the outer surface due to bending is constant, when...

Q:

A simple beam of rectangular cross section (width 4 in., height 10 in.) carries a uniform load of 1200 lb/ft on a span of 12 ft (see figure). Find the principal stresses (1 and (2 and the maximum...

Q:

A simple beam of rectangular cross section has span length L = 62 in. and supports a concentrated moment M = 560 k-in at midspan (see figure). The height of the beam is h = 6 in. and the width is b =...

Q:

A beam of rectangular cross section is simply supported at the ends and subject to the single concentrated force shown below. Determine the shearing stress at a point 3 cm below the top of the beam...

Q:

A cantilever beam of rectangular cross section is subjected to a concentrated load P = 17 k acting at the free end (see figure). The beam has width b = 3 in. and height h = 12 in. Point A is located...

Q:

Consider the beam assembly shown below Two horizonal beam member A B and B D are connected by a double shear pin at B Note that points A and D are a simple roller and pinned supports respectively A 1...

Q:

Q3: q=200 KN/m RAX RAY 40 420 360 20 10 m 5 m Ray Ay -300- NA 15 200 Figure 1 The I profile of the Question-1 is supporting a uniform loading as shown in the figure 3. 1-/ Draw the shear force and...

Q:

In the figure below, two elastic members AB and CD are of rectangular cross section and have the same cross-sectional area A. They are made of the same material with Young's modulus E. They are pined...

Q:

C program C program Once the moment of inertia has been determined, calculate the deflection from the formula: deflection - (PL)(BEI). Print the deflection at the end of the beam in inches, in...

Q:

Show that if 1

Q:

A commercial for a new blender says the following: "You will never guess how much this blender costs! $70? Wrong! $60? No! Not even $50! This blender costs only $25.99!" By asking viewers to consider...

Q:

When the actual amount of a materlal used in production is greater than the standard amount allowed for the schusl outout, the journal artry would include: Multiple Oliste Shere to Manerials...

Q:

Hultquist Corporation has two manufacturing departments--Forming and Customizing. The company used the following data at the beginning of the period to calculate predetermined overhead rates:...