Question: A pump will be used to transfer water between two reservoirs. The elevation difference between the lower ( source ) reservoir and the upper (

A pump will be used to transfer water between two reservoirs. The elevation difference between the lower (source) reservoir and the upper (receiving) reservoir is 10 ft. The reservoirs are connected by 1 mile of 4" uncoated cast iron pipe. Determine the pump head (Hp) required to deliver water to the upper aquifer at a flow rate of 3 gpm using

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

Water at 20C is being pumped from a lower to an upper reservoir through an 8 in Schedule 40 pipe in the system shown the Figure. The water-surface elevations in the source and destination reservoirs...

Q:

A pump is used to transfer water at 70 F (p = 1.94 slug/ft; v = 1.05 x 105 ft/s) from one large reservoir to a second large reservoir. Both reservoirs are open to the atmosphere, and the water level...

Q:

Question 5 Two pipes are connected in series and are used to transfer water from Reservoir A to Reservoir B. Both pipes have an equivalent sand roughness, ks, of 0.06 mm. A steady flow rate of 0.12...

Q:

The following configuration is used to transfer water from one reservoir to another at a higher elevation with both free surfaces exposed to atmospheric pressure. The dimensions and minor loss...

Q:

A pump-motor system is used to transfer water (p = 62.4 lbm/ft & =6.72x10+ lbm/ft.sec) at a steady rate of 4500 lbm/min from a reservoir to a tank located at an elevation of 110 ft., measured...

Q:

A pump is used to transfer water from a lower level reservoir to a higher level tank. The pump has a flow rate of 500 liters per minute and is powered by an electric motor that operates at 90%...

Q:

4. Two reservoirs are connected by a 4 inch diameter, 1000 foot long, concrete pipe (C = 70). The elevation difference between the water level in the two reservoirs is 100 m. a) Select a pump size...

Q:

Paul realizes that the pump being used in Prob. 1439E is not well-matched for this application, since its shutoff head (125 ft) is much larger than its required net head (less than 30 ft), and its...

Q:

Consider the pump and piping system of Prob. 1443. Suppose that the lower reservoir is huge, and its surface does not change elevation, but the upper reservoir is not so big, and its surface rises...

Q:

Suppose that the free surface of the inlet reservoir in Prob. 1443 is 3.0 m lower in elevation, such that z 2 z 1 = 10.85 m. All the constants and parameters are identical to those of Prob. 1443...

Q:

3. The total cost (in millions of dollars) of producing x thousand units of an item is C(x)- 4(x- 1) + 4 a. Make a well-labeled graph of C(x), x20 b. The revenuc (in millions of dollars) from selling...

Q:

A study by researchers at the University of Maryland addressed the question of whether the mean body temperature of humans is 98.6F. The results of the study by P. Mackowiak et al. appeared in the...

Q:

Which of the following is true of special order pricing? A . The special pricing should not be set below the regular price. B . It represents a short - run pricing decision. C . The special price...

Q:

The following account balances were drawn from the financial records of Kent Company (KC) as of January 1, Year 5: Assets, $17,500; Liabilities, $4,700; Common Stock, $8,400; and Retained Earnings,...