Question: An orthogonal cutting operation is performed using a rake angle of 14 degrees, to= 0.017 in and w = 0.1 in. The chip thickness ratio

An orthogonal cutting operation is performed using a rake angle of 14 degrees, to= 0.017 in and w = 0.1 in. The chip thickness ratio is measured after the cut to be 0.61. Determine the chip thickness after the cut.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

An orthogonal cutting operation is performed using a rake angle of 30 degrees, to-0.014 in and w = 0.19 in. The chip thickness ratio is measured after the cut to be 0.63. Determine the chip thickness...

An orthogonal cutting operation is performed using a rake angle of 1 8 on a work material whose shear strength is 2 8 0 MPa . The chip thickness before the cut = 0 . 3 1 m m and width of cut = 2 . 5...

An orthogonal cutting operation is performed using a rake angle of 1 5 . Chip thickness before the cut = 0 . 0 1 2 in and width of cut = 0 . 2 2 0 in . The chip thickness ratio is measured after the...

1. Shear plane angle and shear strain: In an orthogonal cutting operation, the tool has a rake angle = 15. The chip thickness before the cut = 0.31 mm and the cut yields a deformed chip thickness =...

2 0 . 5 ( A ) ( USCS units ) A turning operation is performed using a rake angle of 1 5 . Cutting speed = 2 0 0 f t m i n , feed = 0 . 0 1 2 i n r e v , and depth of cut = 0 . 1 0 0 i n . The chip...

estion 7 5 points " ( USCS units ) The shear strength of a certain work material = 5 0 , 0 0 0 l b i n 2 . An orthogonal cutting operation is performed using a tool with rake angle = 2 0 at a cutting...

The shear strength of a certain work material = 5 0 , 0 0 0 lb / in 2 . An orthogonal cutting operation as illustrated in the figure below is performed using a tool with rake angle = 2 0 \ deg at a...

This is a subjective question, hence you have to write your answer in the Text-Field given below. (a) Using a neat figure show continuous with built-up edge chip formation in metal cutting. Explain...

#2. (20 marks). The shear strength of a certain work material = 50,000 lb./in. An Orthogonal utting operation for the first batch of materials is performed using a tool with rake angle = 20 at...

Shear strength: The cutting force and thrust force have been measured in an orthogonal cutting operation to be 301 lb and 291 lb, respectively. The rake angle = 12, width of cut = 0.400 in, chip...

A process consisting of two CSTR's in series is reasonably well modeled by the following transfer function model: y(s) = 1.5 (12s + 1)(5s + 1) (s) The time constants are in minutes, and the valve and...

Explain in detail what will happen to an insurance company that charges teen-age males the same rates for automobile insurance as it charges its other customers.

what accounts do you credit and debit when paying off pension account

atch the compensation objectives with their meanings. Efficiency Efficiency drop zone empty. Fairness Fairness drop zone empty. Compliance Compliance drop zone empty. Improving performance and...