Question: As the pneumatic controller output in a control valve as signal increase it exerts pressure on the diaphragm which compresses the spring, thus pulling the

"As the pneumatic controller output in a control valve as signal increase it exerts pressure on the diaphragm which compresses the spring, thus pulling the stem out " air-to-close rotary air-to-open no answer is correct

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

The Purpose of the Romeo Engine Plant is to produce the highest quality production engines in the world that meet all of our customers' requirements at a cost lower than the competition, and to...

11-What is the type of controller illustrated in Figure 5? What is mode of control, State the controller output algorithm. Rate Algorithm Trim Gain Figure 5 Operational amplifier Error Signal Input...

1-Describe discrete control and multistep control 2-The figure (1) illustrates automatic water level control system controlled with proportional only controller. The controller is adjusted with set...

FIGURE 5 shows a partially completed diagram of a flow control system. The flow controller is reverse acting and has a 0 . 2 to 1 . 0 bar pneumatic output signal which will supply both control valves...

1. liquid is pumped out of a hold-up tank at a highly variable flow rate of q(t) [L/min] for a reactor downstream. we wish to maintain the liquid level h[m] in the tank at a set point hsp=5[m] by...

Task 1: Multiple production lines exist in a water bottling factory. The most automated part is the filling line, where plastic bottles are placed on a conveyor belt and driven towards a filling...

Consider the pneumatic controller shown in Figure. Assuming that the pneumatic relay has the characteristics that p c = K p b ( where K > 0 ) , determine the control action of this controller. The...

AIR TO COMBUSTION CHAMBER 7-Ratio control is used in fuel combustion process. Figure 2 shows a block diagram of combustion process. Answer the following questions a) Which component control the ratio...

Explain this system, identifying the controller, actuator and process and sensor? Process Control The level in the tank remains constant when the input flow rate equals the output flow rate. The...

The liquid level in a tank is controlled using a Pneumatic proportional controller as shown the figure below. The level sensor is able to measure over the range 1.85 to 2.25 m. it is found that,...

A 200-lb crate is attached to the trolley-beam system shown. Knowing that 1.5 a = ft, determine (a) The tension in cable CD, (b) The reaction at B. 55 1.50

"tic" data is in "ISwR" package. To access this data you need to first install "ISwR"package. Then load the library. 1. To install package "ISwR" in R use the command: install.packages("ISwR")

2 Work out these subtractions. Show all the steps in your working. a T 23/3-1/13 35 b 4-2 C d 6-30

analyse prescriptive and emergent approaches with the implication on how organization can use the different approaches to counter react and adapt to the changing environment.

The report will be written by Leslie Cartwright.

The failure to record the transaction was mine.

We are dependent on their services for our operation.