assembly language please show your work

17. List the three (3) primary steps of the instruction execution cycle, in sequential order. a. b. c. d. fetch, decode, memory write fetch, memory read, execute decode, fetch, execute fetch, decode, execute 18. Which flag is set when an unsigned value is too large to fit into a destination operand a. Sign b. Carry c. Overflow d. Auxiliary Carry 19. Which of the following correctly describes the sequence of reading from memory during single clock cyele? a. Read line set low; Address placed on bus; Operand placed on data bus by memo controller; Read line set high, indicating that data bus contains the requested da dress placed on bus; Operand placed on data bus by memory controller; Rea line set low; Read line set high, indicating that data bus contains the requested d c. Address placed on bus; Read line set low; Read line set high, indicating that dat bus contains the requested data; Operand placed on data bus by memory contro d. Address placed on bus; Read line set low; Operand placed on data bus by memo controller; Read line set high, indicating that data bus contains the requested da b. Ad 20. Which register is known as a loop counter? a. EAX b. EBX c. ECX d. EDX 21. Which mode is the native state of the Intel processor? a. Protected mode b. Virtual-8086 mode c. Real-address mode d. System management mode 22. Which type of RAM is typically used for cache memory? a. Static RAM b. Dynamic RAM c. CMOS RAM d. Video RAM 23. Translate the following binary number to decimal: 01001001 a. 34 b. 18 c. 6 d. 73