Question: Assume that all the routers have the same OSPF priority IDs with the below configuration R1: OSPF Router ID: 35.255.255.1 Loopback Interface 0: 192.168.40.1 Loopback

Assume that all the routers have the same OSPF priority IDs with the below configuration R1: OSPF Router ID: 35.255.255.1 Loopback Interface 0: 192.168.40.1 Loopback Interface 1: 192.168.50.1 Fa 0/1: 192.168.10.1 Se 0/0: 172.16.100.1

R2: OSPF Router ID: Not Configured Loopback Interface 0: 192.168.40.1 Loopback Interface 1: Not Configured Fa 0/1: 192.168.10.2

R3: OSPF Router ID: Not Configured Loopback Interface 0: 192.168.80.1 Loopback Interface 1: Not Configured Fa 0/1: 192.168.10.3

R4: OSPF Router ID: 1.1.1.1 Loopback Interface 0: 192.168.33.1 Loopback Interface 1: 192.168.34.1 Fa 0/1: 192.168.10.4 Fa 0/0: 10.10.10.10

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

a-What is the router ID of R1? (write only the IP in IPv4 format) * b-What is the router ID of R2? (write only the IP in IPv4 format) * c-What is the router ID of R3? (write only the IP in IPv4...

PLEASE HELP WITH THIS NETWORKING LAB PRACTISE Addressino Table Part 1: Open the prepared Packet I racer simulation file (from Part I). Part 2: Configure Single-Area OSPFv2 (Ignore all the red font...

Week 5-- OSPFv2 Configurations 1) Subnet the network, given the IP = 192.168.10.0 /24 LAN 1 = 30 Hosts /27 =255.255.255.224 27 26 = 1, 21 = 2 subnets Block size = 256 224 = 32 192.168.10.64 /27 (.65...

Lab Task 4: Configure R1 for Inter-VLAN Roliting Configure the router on the Office 1 network to allow multiple VLANs to communicate on the network. Perform steps 14 on R1. 1 Enable GigabitEthernet...

for cisco Continuing to the previous lab ( OSPF Basic Configuration_ Lab Demo), we will assume that OSPF protocol is already configured on the routers. So if you didn't complete the previous lab,...

Building Task 2: Cable a network that is similar to the one in the Topology Diagram. Default Route R3 VLAN 10 Link $3 VTP Server VLAN 10 PC6 VLAN 20 R BOR OSPF Routing DR Trunk Link PC7 VLAN 30 This...

3. (20 points) Assume you are in a private network connected to the Internet via a router. Your node's IP address is 192.168.45.121/28 Net ID in decimal? Range of valid IPs? to Which IP address is...

Analyse the behaviour of network protocols by answering the following: ( a ) Assume that all the routers in the network shown in Figure Q 5 are enabled with only Routing Information Protocol version...

Question 4 Figure Q 4 shows the network topology of a company. Figure 0 4 Analyse the behaviour of network protocols by answering the following: ( a ) Assume that all the routers in the network shown...

#Computer networks #Packet tracer #Task B only I need Task B only. I m also attaching Task A results in the below table. Task A Full answer and results are attached below: #Computer networks ANSWER...

A small municipal well was pumped for 2 hr at a rate of 15.75 liters/s (0.556 cfs). An observation well was located 50 ft from the pumping well and the following data were recorded. Using the Theis...

Klumper Corporation is a diversified manufacturer of industrial goods. The company's activity-based costing system contains the following six activity cost pools and activity rates: Activity Cost...

Which of the following statements is true based on the historical record for 1 9 2 6 - 2 0 2 2 ? Multiple Choice Fisk - free securties produce a poshlive real rabe of retum each year. Bonds are...

44. Bryant Manufacturing produces its product in two sequential processing departments. During October, the first process finished and transferred 340,000 units of its product to the second process....

LO2 Distinguish among three types of performance information.

2. How would you evaluate the effectiveness of the Leadership Academy?

1. What are the pros and cons of rotating participants from in-class training back to the worksite every two weeks? What support would be needed at the worksite to ensure that the trainees get the...