Question: Based on the shift register schematic below, write an Arduino program that enables a chase effect on LEDs (your chosen LEDs). Code that you

Based on the shift register schematic below, write an Arduino program that enables a chase effect on LEDs (your chosen LEDs). Code that you may use are byte ledPin[], millis(), pinMode(pin mode) and digitalWrite(pin.value) QB 1 16 VCC Qc 2 15 QA QD 3 14 SER QE 4 13 OE QF 15 12 RCLK QG 16 11 | SRCLK QH7 10| SRCLR GND 8 9QH'
Step by Step Solution
There are 3 Steps involved in it
To create a chase effect on LEDs using a shift register you can use the Arduino shiftOut function to shift bits into the shift register enabling LEDs ... View full answer
Get step-by-step solutions from verified subject matter experts
