By using the TRILOGI software, simulate the steps and generate the ladder diagram based on narrative statement, input and output port table and flowchart below. You should capture results based on each condition of your simulations and present them in your report. You may use "Print Screen" to capture your simulation results. You must also include the ladder diagram generated from your simulations in your report. 1. Narrative Statement 1) ii) Start the bottle conveyor When a bottle is in position a. Stop the conveyor b. Open the output valve When the bottle is full a. Close the output valve Repeat i) iii) iv) 2. Input and Output Port Table Input Port X X X X Start Stop Sensor BP Sensor BF 3. Flow chart Output Port Yo Y. psy Conveyor Motor Valve START Start buton Pressed? Yes Run ON Start Conveyor Motor Boein Posit Stop Conveyor Motor Open Visive Bottle Fu Yes Close Ve Stop Buton Pressed? Ves Run OFF END No No No No Discussion Write a short report to discuss your answers. Your report should contain a short introduction, some explanation on ladder logic, your experimental procedure, and the results you obtain at every stage of the simulation.