C3. Given the network spology and IPv6 addressing table below, write the necessary commands to configure single area OSPF/3. Con, S000 F1 S2 tro LANA:2001:42 B2C2.64 VANLIK 2001A1B1C164 S4001 LAND 2001:33:54 GOLF%2 Gigo Durk PCI Fao LANC 2001A4 34:04:164 POO Device bi IPV6 Addressing Table IP Address/Prefix 2012 12C21/64 2001 C 1/64 200LBURBCI 1/64 2001 DACA 1/64 2001.01 1/64 2001 AURA CA F/64 200LBURB.CF/64 2002A2.1.2.2 F/64 Interface 60/O so/0/0 G0/0 G0/1 so/0/1 NIC NIC NIC Dunk Default Gateway N/A N/A N/A N/A N/A FE80::1 FE80::2 FE80:3 POO PCB PC2 Use the following requirements to configure OSPF routing on two routers: Process ID 1, Area 1 Router ID for each router: tha = 1.1.1.1 Dunk - 2.2.2.2 1. Write the command to enable IP6 unicast routing in both routers. b. Enable OSPFv3 on all interfaces in router c. Enable OSPFv3 on all interfaces in Dunk router. d. Write the command to display the routing table. c. Write the command to assign link-local address on interface Gigot of this router f. Write the command to verify OSPF3 neighbors