Question: Class is Heat Transfer. Please show all steps and will rate question. For Part a). I got 49.98W but not sure if it is right.

Class is Heat Transfer. Please show all steps and will rate question.

For Part a). I got 49.98W but not sure if it is right.

A 1.0 mm thick stainless steel (k = 36 W/mC) circumferential fin of rectangular profile is installed on a tube having a diameter of 2.0 cm. The outer radius of the fin is 4.0 cm. The inner tube is maintained at 250C and the assembly is exposed to a convection environment having To =35 C and h = 50 W/m C. Calculate (a) the heat lost from ONE fin and (15 points) (b) the effective of the fin. (10 points)

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

Please quality check my solutions for this advanced heat transfer problem. Show all work. Thank you. All original documents are located at the bottom. 3.9 COMPACT HEAT EXCHANGERS 3.9.10-1 3.9.10...

Please show all steps on how answers were found. will also rate the question, thank you! class is Heat Transfer a 2. Water at a temperature of 100 C having a thermal conductivity of 0.630 W/m C flows...

Question is from Heat Transfer class. Please show all steps on how you got the answer, Thank you! Will also rate the question. Crude oil is transported from a storage to a refinery through a 10"...

Please evaluate the quality of the design (answer questions within 1-4 on the gas turbine recuperator rating problem). Please answer all questions asked. Show all calculations. I have provided...

Please read the question Question: Choose another different one of the teaching strategies from the article that you read 1. What is the teacher is trying to accomplish by using this technique? (That...

Please read the question Question: Choose one of the teaching strategies from the article that you read 1. What is the teacher is trying to accomplish by using this technique? (That is, what's the...

s ask for just cause 1. How long has the employee has been working for the company 2. Disciplinary record 3. Notice of expectations 4. Disparate treatment 5. Adequate investigation 6. Progressive...

Can an expert in advanced heat transfer review my work and verify my solutions. Please show all work where corrections are needed. I have uploaded the original problem materials for reference as...

Please read chapter 6 and answer the questions and see the ( guide to answer number 3) For each case study, you will view the material as the student's teacher, read the information provided and...

Please read chapter 6 and answer the questions and see the ( guide to answer number 3) 1. Decide what assessment you would like to do to provide you with more information about the student, 2....

You are assigned to a committee of three to decide on a dress code for Campbellsville University Staff and Faculty. Only two of the three votes are required to pass this policy. In this situation you...

Bean county recently acquired a commercial office building at a cost of $20 million, paid in cash. it estimates that the economic life of the building is 40 years (with no salvage value) not...

The term disintermediation refers to The policy of not closing insolvent institutions in hopes they could eventually recover. Withdrawal of deposits from depository institutions that are reimested in...

(A) How long does a station, s , have to wait in the worst case before it can start transmitting its frame over a LAN that uses the basic bit-map protocol? (B) Consider the delay of pure ALOHA versus...

How will evidence from PLCs and walkthroughs inform teacher evaluations?

Do I need to adjust strategies I have in place to ensure my participation in all professional learning?

What revisions need to be made to the school improvement plan for next year based on this years data?