cnc lathe program chapter 5

QUESTION 1 The time it takes for a CNC program to produce a single part is typically called the Program Production O Circuit Cycle QUESTION 2 Which of the following is not a factor that may affect the cycle time? Type of material Amount of material to be removed Size and complexity of the part Spindle direction QUESTION 3 True or False: The cycle time of the part has a direct effect on the amount it will cost to produce a part. True False QUESTION 4 cycle time is often created so that each section of the program can be performed without running the entire program A CNC program with a Short Long Hata STONES QUESTION 4 cycle time is often created so that each section of the program can be performed without running the entire program. A CNC program with a O Short O Long Moderate Variable QUESTION 5 _sections allows an operator to quickly repair a feature on a part that is not in tolerance. Creating a program with Unique Sequential Independent Dependent QUESTION 6 True or False. The operator must be thoroughly trained on the procedure of only running a section of the entire program True False QUESTION 7 sections requires the repetition of commands and instructions in each section A CNC program with Unique Sequential Click Save and Submit to save and submit. To Save Al Al Save 403- wontent_=_2062563_1&step=nul QUESTION 7 sections requires the repetition of commands and instructions in each section A CNC program with Unique Sequential Independent Dependent QUESTION 8 To run an independent section of a program separately, the operator must set the controller to start the section at the Header O Safe start block Spindle command Linear movement command QUESTION 9 word, which allows the operator to search through the program CNC programmers often identify the safe start block for an independent section with an in the controller to locate the first block of a required section. QUESTION 10 Click Save and submit to save and submit Click Save All Answers to Sate e rs Save ON QUESTION 10 that are repeated in each Units, spindle restraints, spindle commands, feedrate controls, and coolant commands are all examples of typical independent section O Words e Commands e Letters Rules QUESTION 11 True or False: A CNC programmer must have knowledge on each machining operation to create movement commands within each section True False QUESTION 12 True or False Building a CNC lathe program that is versatile requires organizing sections into an order that will safely produce a part that meets all of the required specifications True False Click Save and Subinit to save and submit. Click Save All Ansters to save all ansicers