Configure RIPv$2$ on a network using Packet Tracer and ensure proper routing between routers.

Topology:

$$ Use three routers $($Router$0,$ Router$1,$ Router$2).$ And three switches and three PCs$.$

$$ Connect routers as follows:

o Router$0$ to Router$1($Serial connection$)$

o Router$1$ to Router$2($Serial connection$)$

o Between Routers and switches, use Gig$0/0.$

Tasks:

$1.$ IP Addressing:

o Assign IP addresses to each interface of the routers $($provide screenshot$).$

o You must use your university ID as an IP address $($provide your ID number, explain how you create subnets from your ID$,$ and show where you will implement these IPs$)($explain and provide screenshots$).$ Fill in the table below.

For example, Your ID is $202330130.$

$$ The first subnet could be $202\mathrm{.}33\mathrm{.}01\mathrm{.}30/28$: $1$st valid IP is $202\mathrm{.}33\mathrm{.}1\mathrm{.}17,$ and the last valid IP is $202\mathrm{.}33\mathrm{.}1\mathrm{.}30($this network will be used in subnet $1,$ on router$0$ gig$0/0$ interface$)$

$$ Second subnet: $202\mathrm{.}33\mathrm{.}01\mathrm{.}35/28$: $1$st valid IP is $202\mathrm{.}33\mathrm{.}1\mathrm{.}33,$ and the last valid IP is $202\mathrm{.}33\mathrm{.}1\mathrm{.}46($this network will be used in subnet $2,$ on router$0$ serial$0/0/0$ interface and router$1$ s$0/0/0$ interface$)$

$$

$$ Third subnet: $202\mathrm{.}33\mathrm{.}01\mathrm{.}5/28$: $1$st valid IP is: $202\mathrm{.}33\mathrm{.}1\mathrm{.}1,$ and the last valid IP is $202\mathrm{.}33\mathrm{.}1\mathrm{.}14.....$

$$ Etc...

$2.$ Router Configuration:

o Configure RIPv$2$ on all routers. Use the passive interfaces and default network $($provide screenshots for each router$).$

o Enable RIPv$2$ on the necessary interfaces.

$3.$ Routing Information:

o Configure static routes if needed $($provide screenshots$).$

o Ensure that all routers have correct routing information in their routing tables $($provide screenshots for each router$).$

$4.$ Verification:

o Use the show commands to verify the RIP configuration $($provide screenshots for each router$).$

o Check the routing tables on each router to confirm proper routing $($provide screenshots for each router$).$

$5.$ Testing:

o Ping from one PCs to another to ensure end$-$to$-$end connectivity.