Create a PLC ladder logic program using the basic I$/$O Simulator of

LogixPro that will perform the following timed output operation.

When a toggle switch is closed, a one$-$second timer is put in a

continuous loop. $($When the timer reaches its preset time of one

second, the done bit will be set and the timer will immediately reset

and start timing over again$)$

The output of the timer should increment an Up Counter once per

second.

After $5$ seconds, an output must be turned on$.$

A second counter must also be incremented once per second.

After $10$ seconds, a second output must be turned on$.$

Turning the original toggle switch off should reset the timer and both

counters.