.cseg .org 0;Initialization code; Do not move or change these instructions or the registers they refer to.; You may change the data values being loaded.; The default values set A = 0x3412 and B = 0x0003 ldi r16, 0x12; Low byte of operand A ldi 17, 0x34 High byte of operand A ldi r18, 0x03; Low byte of operand B ldi r19, 0x00 High byte of operand B;Your task: Perform the integer division operation A/B and store the result in data memory.; Store the 2 byte quotient in DIV1: DIV0 and store the 2 byte remainder in MOD 1: MOD0.; ...Your code here ...;End of program (do not change the next two lines) stop; rjmp stop;Do not move or modify any code below this line You may add extra variables if needed.; The .dseg directive indicates that the following directives should apply to data memory .dseg .org 0x200;Star assembling at address 0x200 of data memory (addresses less than 0x200 refer to registers and ports) DIV0: byte 1; Bits 7...0 of the quotient DIV1: .byte 1 Bits 15...8 of the quotient MOD0: byte 1; Bits 7. .0 of the remainder MOD1: byte 1; Bits 15... 8 of the remainder