Design a 4-bit ALU using Unit 1 and Unit 2. The control signal A/L will indicate which operation the ALU will perform (when the control signal is 0 perform Arithmetic, otherwise if the signal is 1 then perform Logic).

Unit 1:

Design a 4-bit adder/subtractor that accepts two 4-bits numbers, A and B, and either add them up (A + B) or subtract them (A B) depending on a control signal A/S (when the control signal is 0 perform ADD, otherwise if the signal is 1 then perform SUB). The result will be stored in C.

Unit 2:

Design a 4-bit AND/OR unit that accepts two 4-bits numbers, A and B, and either AND them or OR them depending on a control signal A/O (when the control signal is 0 perform AND, otherwise if the signal is 1 then perform OR bitwise logical operation). The result will be stored in C.

B A B A2 B A Bo A C3 C2 Ci FA S3