Design and simulate a network model as shown

below using Cisco Packet Tracer

Assume that your student ID number is $S0000001234,$ where

$id1=1,id2=2,id3=3$ and $id4=4$

Do the following Tasks:

Set all the router's name based on your student

id as shown in figure $0\mathrm{.}5$Mark

Set an enable password as cisco for all routers

Mark$]$

Configure IP address to all the routers interfaces

and PCs based your student id as shown in figure

and make sure that all interfaces' links are up $[2$

Marks$]$

Configure dynamic RIP routing protocol in all

routers $[1\mathrm{.}5$ Marks$]$

Configure dynamic OSPF routing protocol in all

routers $[1\mathrm{.}5$ Marks$]$

Configure a Telnet using ud$123$ as password in all

router and verify Marks$]$

Configure a Standard Access List to deny Ping to

router S$1234$D from all other routers $[1$ Mark$]$

Configure an Extended Access List to deny

Telnet to router S$1234$C from router S$1234$A and

S$1234$B $[1\mathrm{.}5$ Marks$]$

Project Presentation and Questions $[5$ Marks$]$