Question: Determine the natural angular frequency, the damping factor, the rise time, percentage overshoot and 2 % settling time for systems with the following transfer functions:

Determine the natural angular frequency, the damping factor, the rise time, percentage overshoot and 2% settling time for systems with the following transfer functions: (a)100/(s2+4s +100),[6 marks](b)49/(s2+45+49).[6 marks](c) Comment on the results. [3 marks]

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Figure 2. Antenna position control system (schematic). Modified from (Nise, 2020). An antenna position control system as described in Figure 1 is utilizing the following motor and load as shown in...

Q:

The steering input controls the lateral motion of the vehicle (see Figure 1). The automated vehicle steering control system uses information about the vehicle position relative to the center of the...

Q:

2. (a) Identify and give a brief explanation of the two main ways that dynamic models of a chemical process may be obtained. State one advantage of each method. (8) (b) Using the graph paper...

Q:

For the following transfer functions, compute the undamped natural frequency wn the damping ratio and the steady state gain K. State whether the system is underdamped, overdamped, critically damped...

Q:

For the flexible body of Figure 2. Determine the open and closed loop transfer functions. ( Determine the steady state error if . Suggest a solution to ensure no steady-state error. Using...

Q:

The following unit step response curves come from linear systems that have each either one pole or two poles and no zeros. Identify the model of each system. That is, for a first order system find...

Q:

This is a desktop based activity focussing on deriving the characteristic equation of DC motor followed by obtaining the behaviour of system in time and frequency domains using computer simulation...

Q:

I. a. QUBE-SERVO 2 Modeling: You have to compute value of 'K'and tau' when a 4V step input is applied to the virtual QUBE-Servo 2. The step input will be applied instantaneously (at time 0 second)...

Q:

6) A continuous time plant with transfer function is to be included in the control system of Figure 1, with D(z) = K and T = 0.1s: system a) Find the open loop discrete transfer function of the b)...

Q:

Please include detailed MATLAB steps, so I can execute the MATLAB code on my device Unit Step Response 0.06 100 90 80 0.05 Mp: Maximum overshoot 0.04--- 0.03 0.02 60 Mp 50 40 30 20 10 0 0.5 2 2,5 3...

Q:

Find the indicated probabilities using the geometric distribution, the Poisson distribution, or the binomial distribution. Then determine if the events are unusual. If convenient, use the appropriate...

Q:

Based on the following control chart, does the processappear to be in statistical control? Justify your decision. 18 16 14 12 10 6

Q:

Astatic budget is appropriate in evaluating a manager's performance if the company prepares reports on an annual basis. the company is a not - for - profit organization. actual activity is less than...

Q:

Blossom Company uses a job order cost system and applies overhead to production on the basis of direct labor costs. On January 1. 2022, Job 50 was the only job in process. The costs incurred prior to...