DO the Following Code Using MATLAB:

2. (12 points) Many heat exchangers use fins to increase surface area and improve heat transfer. In one particular design, each plate of a heat exchanger is packed 18 with conical frustrums, as shown in the diagram below. The radius of the bottom of the fin (R) is fixed at 0.75 in. and the height of the fin (h) is fixed at 1.25 in. However, manufacturing allows the radius of the top of the fin (R2) to vary to provide the necessary surface area for a particular heat transfer application. Side View Top View Given that the surface area (SA) of a single conical frustrum is given by SA = (R1 + R2) (R1-R2)2 + h2 use a while loop to determine the minimum value of R2 needed for the fins to provide a total surface area of at least 95 in2 per plate