Question: In a pipeline, water is flowing. A manometer is used to measure the pressure drop for the flow through the pipe. The difference in

In a pipeline, water is flowing. A manometer is used to measure

In a pipeline, water is flowing. A manometer is used to measure the pressure drop for the flow through the pipe. The difference in level was found to be 20 cm. If the manometric fluid is CCI4, find the pressure drop. If the manometric fluid changed to mercury, what will be the difference in the level? (Given that the density of CCI = 1.596 g/cm3 and density of mercury = 13.6 g/cm3)

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

A differential manometer is used to measure the pressure change caused by a flow constriction in a piping system as shown. Determine the pressure difference between points A and B in psi. Which...

A simple U-tube manometer is used to measure the pressure of oil (sp. Gr. 0.8) flowing in a pipe line. The pressure in the pipe is vacuum. Find the vacuum pressure in pipe. Its right limb is open to...

A U-tube mercury manometer is used to measure the pressure at a point on the wing of a wind-tunnel model. One side of the manometer is connected to the model, and the other side is open to the...

An inclined tube manometer is used to measure the pressure drop in an elbow through which water is flowing (see Figure P4.10). The manometer fluid is an oil with $\mathrm{SG}=1.15$. The distance $L$...

An orifice with a 1.8-in-diameter opening is used to measure the mass flow rate of water at 60F ( = 62.36 lbm/ft 3 and = 7.536 10 4 lbm/fts) through a horizontal 4-in-diameter pipe. A mercury...

An inclined manometer is used to measure the pressure drop between two taps on a pipe carrying water, as shown in Figure P4.13. The manometer fluid is an oil with $\mathrm{SG}=0.92$, and the...

As shown in Fig.P1.46, an inclined manometer is used to measure the pressure of the gas within the reservoir. (a) Using data on the figure, determine the gas pressure, in lbf/in.2 (b) Express the...

Gas absorption or gas scrubbing is a commonly used method for removing environmentally undesirable species from waste gases in chemical manufacturing and combustion processes. The waste gas is...

An open-end mercury manometer is to be used to measure the pressure in an apparatus containing a vapor that reacts with mercury. A 10 cm layer of silicon oil (SG = 0.92) is placed on top of the...

A tank contains a liquid of unknown density (see Figure P4.25). Two dip tubes are inserted into the tank, each to a different level in the tank, through which air is bubbled very slowly through the...

What is the difference between substantive and procedural law? Give an example of each.

The spot rate between the U.S. dollar and the New Zealand dollar is $1 = NZD1.1867. If the interest rate in the United States is 5 percent and in New Zealand is four percent, then what should be the...

Current Attempt in Progress The main purpose of the Pension Benefit Guaranty Corporation is to administer terminated plans and impose liens on the employer's assets for certain unfunded pension...

Ecommerce has changed the way goods and services are obtained. How do companies like Amazon.com continue to anticipate customer needs?

Estimation of the thermal conductivity of a dense gas, predict the thermal conductivity of methane at 110.4atm and 127F by the following methods: (a) Use Fig. 9.2-1. Obtain the necessary critical...

Using the data given for Eco Savers Corporation in E6A and assuming that the company uses the average costing method, compute the equivalent units of production for direct materials and conversion...

Computation of the Prandtl numbers for gases at low density. (a) By using the Eucken formula and experimental heat capacity data, estimate the Prandtl number at 1atm and 300K for each of the gases...

The national sales manager for "I colored this" (ICT) T-shirts provides all salespersons with the payoff table shown next, giving the estimated profit when a retailer purchases from one to four dozen...

They are charge with directing the work and observing the behavior and performance of the men under his unit.

A venturi meter is a device to measure fluid flow rates, which in its operation resembles the orifice meter (Section 3.2b). It consists of a tapered Constriction in a line, with pressure taps leading...

Nikes approach to managing supplier responsibility has greatly evolved since the 1990s when the media uncovered claims of child labor, underpaid workers, and poor working conditions in several Asian...

May someone help me on two word problems? I don't understand the questions and don't know where to begin. I appreciate you, thank you for all your help!! 35. PRODUCTION SCHEDULING A division of the...

Hard to solve Question1 The water-supply manager for Philadelphia needs to supply the city with at least 16 million gallons of potable water per day. The supply may be drawn from the local reservoir...

The water-supply manager for Pittsburgh needs to supply the city with at least 14 million gallons of potable water per day. The supply may be drawn from the local reservoir or from a pipeline to an...

Topgrade Turf Lawn seed mixture contains three types of seed: bluegrass, we, and Bermuda. The costs per pound of the three types of seed are 1o cents, 13 cents, and :5 cents, respectively. In each...