EXPERIMENT 2: NEWTON'S THIRD LAW AND FORCE PAIRS DATA SHEET Suspension Set Up 0.5 kg Mass...
Fantastic news! We've Found the answer you've been seeking!
Question:
Transcribed Image Text:
EXPERIMENT 2: NEWTON'S THIRD LAW AND FORCE PAIRS DATA SHEET Suspension Set Up 0.5 kg Mass on 10 N Spring Scale Table 3. Forces on a Stationary Spring Force on Stationary 10 N Spring Scale (N) 0.5 kg Mass with String on 10 N Spring Scale 0.5 kg mass, string and 5 N Spring Scale on 10 N spring scale Force on Stationary 5N Spring Scale (N) 0.5 kg mass, string and 5 N Spring Scale on 10 N spring scale on Pulley Table 4. Spring Scale Force Data Force (N) on 10 N Spring Scale Force (N) on 5 N Spring Scale. Post-Lab Questions 1. Compare the magnitude of the forces on both spring scales after you pulled the 5 N spring scale suspended on the 10 N spring scale. 2. Compare the magnitude of the forces on both spring scales after you pulled the 10 N spring scale suspended on the 5 N spring scale. 3. Use Newton's 3rd Law to explain your observations in Questions 1 and 2. 4. Compare the force on the 10 N spring scale when it was directly attached to the 0.5 kg mass and when there was a string between them. 5. Compare the force on the two spring scales in Steps 5 and 6. What can you conclude about the tension in a string? Table 3. Forces on a Stationary Spring Force on Stationary 10 N Spring Scale (N) 5.5 N Force on Stationary 5N Spring Scale (N) Suspension Set Up 5 kg Mass on 10 N Spring Scale 5 kg Mass with String on 10 N Spring Scale 0.5 kg mass, string and 5 N Spring Scale on 10 N spring scale 0.5 kg mass, string and 5 N Spring Scale on 10 N spring scale on Pulley 5 N Table 4. Spring Scale Force Data Force (N) on 10 N Spring Scale 5.0 N 5.1 N 5.5 N 6.0 N Force (N) on 5 N Spring Scale 5 N 5 N st-Lab Questions Compare the magnitude of the forces on both spring scales after you pulled the 5 N spring scale suspended on the 10 N spring scale. Compare the magnitude of the forces on both spring scales after you pulled the 10 N spring scale suspended on the 5 N spring scale. Use Newton's 3rd Law to explain your observations in Questions 1 and 2. Compare the force on the 10 N spring scale when it was directly attached to the 0.5 kg mass and when there was a string between them. Compare the force on the two spring scales in Steps 5 and 6. What can you conclude about the tension in Wenn EXPERIMENT 2: NEWTON'S THIRD LAW AND FORCE PAIRS DATA SHEET Suspension Set Up 0.5 kg Mass on 10 N Spring Scale Table 3. Forces on a Stationary Spring Force on Stationary 10 N Spring Scale (N) 0.5 kg Mass with String on 10 N Spring Scale 0.5 kg mass, string and 5 N Spring Scale on 10 N spring scale Force on Stationary 5N Spring Scale (N) 0.5 kg mass, string and 5 N Spring Scale on 10 N spring scale on Pulley Table 4. Spring Scale Force Data Force (N) on 10 N Spring Scale Force (N) on 5 N Spring Scale. Post-Lab Questions 1. Compare the magnitude of the forces on both spring scales after you pulled the 5 N spring scale suspended on the 10 N spring scale. 2. Compare the magnitude of the forces on both spring scales after you pulled the 10 N spring scale suspended on the 5 N spring scale. 3. Use Newton's 3rd Law to explain your observations in Questions 1 and 2. 4. Compare the force on the 10 N spring scale when it was directly attached to the 0.5 kg mass and when there was a string between them. 5. Compare the force on the two spring scales in Steps 5 and 6. What can you conclude about the tension in a string? Table 3. Forces on a Stationary Spring Force on Stationary 10 N Spring Scale (N) 5.5 N Force on Stationary 5N Spring Scale (N) Suspension Set Up 5 kg Mass on 10 N Spring Scale 5 kg Mass with String on 10 N Spring Scale 0.5 kg mass, string and 5 N Spring Scale on 10 N spring scale 0.5 kg mass, string and 5 N Spring Scale on 10 N spring scale on Pulley 5 N Table 4. Spring Scale Force Data Force (N) on 10 N Spring Scale 5.0 N 5.1 N 5.5 N 6.0 N Force (N) on 5 N Spring Scale 5 N 5 N st-Lab Questions Compare the magnitude of the forces on both spring scales after you pulled the 5 N spring scale suspended on the 10 N spring scale. Compare the magnitude of the forces on both spring scales after you pulled the 10 N spring scale suspended on the 5 N spring scale. Use Newton's 3rd Law to explain your observations in Questions 1 and 2. Compare the force on the 10 N spring scale when it was directly attached to the 0.5 kg mass and when there was a string between them. Compare the force on the two spring scales in Steps 5 and 6. What can you conclude about the tension in Wenn
Expert Answer:
Related Book For
Physics for Scientists and Engineers A Strategic Approach with Modern Physics
ISBN: 978-0133942651
4th edition
Authors: Randall D. Knight
Posted Date:
Students also viewed these law questions
-
A 5.0 kg mass hanging from a spring scale is slowly lowered onto a vertical spring, as shown in FIGURE EX9.29. The scale reads in newtons. a. What does the spring scale read just before the mass...
-
A 120-mm-radius pulley of mass 5 kg is attached to a 30-mm-radius shaft which fits loosely in a fixed bearing. It is observed that motion of the pulley is impending if a 0.5-kg mass is added to block...
-
A crate of mass 10.0 kg is pulled up a rough incline with an initial speed of 1.50 m/s. The pulling force is 100 N parallel to the incline, which makes an angle of 20.0 with the horizontal. The...
-
Charlie invested $2,000 at the end of 2015, $2,500 at the end of 2016 and $550 at the end of 2017.She earned 8% on her investment.How much money did she have at the end of 2017?
-
Which of the following phenomena would be either consistent with or a violation of the efficient market hypothesis? Explain briefly. a. Nearly half of all professionally managed mutual funds are able...
-
In 2013 about 66% of full-time law enforcement workers were sworn officers, and of those, 88.4% were male. Females however make up 60.7% of civilian employees. Choose one law enforcement worker at...
-
The entry to record the payment of $1,200 rent expense would be which of the following? DATE ACCOUNTS POST REF. DR. CR. a. Rent Expense 1,200 Accounts Payable 1,200 b. Cash 1,200 Rent Expense 1,200...
-
Discuss (1) the information content, or signaling, hypothesis, (2) the clientele effect, and (3) their effects on distribution policy. MINI CASE Southeastern Steel Company (SSC) was formed 5 years...
-
8. Pareto Analysis (6 marks) a. Research into causes production line stoppages at Solstella Energy over the past four months has revealed the following data on the most common causes. Prepare a...
-
Sebastian Trains Co (ST) is a UK based rail operating company which holds three UK rail franchises. The franchises allow ST to run trains on the rail network in a particular geographical area within...
-
1. Over time, there has been significant legislation passed, such as Sarbanes-Oxley, yet corporate fraud is still pervasive in todays business environment. Suggest three (3) new ways that you believe...
-
The "Best Independent Set" problem is defined as follows: Input: An undirected graph G, in which each vertex is marked by a positive value; and a target value T. Goal: A set of vertices S such that...
-
Could you elaborate on the intricate dynamics of mortgage-backed securities (MBS) markets, including the securitization process, credit enhancement mechanisms, and the role of structured finance...
-
3. Given the following equations representing the behavior of producers and consumers: Consumers: Qd = 1,235 - 7P, Producers: Qs =58P, (P: Price) (Qd: quantity demanded, Qs: Quantity supplied) (15%)...
-
3. This table provides some information about hourly output and revenue for a firm in a competitive market. Each factor of production (L) in the table represents one worker. For example, a total of 3...
-
Using the relationship a = exp (ln (a)) -- for example, in Audit Class 1, a = e 6.13 = 459 -- we can determine the equation for Normalized Cumulative ATR for each audit class as a function of the...
-
W ^^^^^^^^^ L d (A) (B) The cantilever shown in Figure A has a square cross-section with a side length of d = 3 mm (figure B). If the density and the yield strength of the material that the bar is...
-
A test car is driven a fixed distance of n miles along a straight highway. (Here n Z+.) The car travels at one mile per hour for the first mile, two miles per hour for the second mile, four miles...
-
Figure 37.7 identified the wavelengths of four lines in the Balmer series of hydrogen. a. Determine the Balmer formula n and m values for these wavelengths. b. Predict the wavelength of the fifth...
-
A horizontal spring with spring constant 100 N/m is compressed 20 cm and used to launch a 2.5 kg box across a frictionless, horizontal surface. After the box travels some distance, the surface...
-
Which of the following are inertial reference frames? Explain. a. A car driving at steady speed on a straight and level road. b. A car driving at steady speed up a 10 incline. c. A car speeding up...
-
For the data set a. Find the first and third quartiles. b. Find the IQR. c. Find the upper and lower outlier boundaries. d. List all the values, if any, that are classified as outliers. 15 7 2 4 4 3...
-
A population has mean = 25 and standard deviation = 4. a. Find the z-score for a population value of 16. b. Find the z-score for a population value of 31. c. What number has a z-score of 2.5?
-
For the data set 37 82 20 25 31 10 41 44 4 36 68 a. Find the first and third quartiles. b. Find the IQR. c. Find the upper and lower outlier boundaries. d. List all the values, if any, that are...
Study smarter with the SolutionInn App