Question: For a loose sand sample and a dense sand sample consolidated to the same effective stress a) ultimate strength is same and also peak strength

For a loose sand sample and a dense sand sample consolidated to the same effective stress

a) ultimate strength is same and also peak strength is same

b) ultimate strength is different but peak strength is same

c) ultimate strength is same but peak strength of dense sand is greater than that of loose sand

d) ultimate strength is same but peak

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

3 . ( a ) A loose sand sample with a critical state friction angle of \ ( 2 8 ^ { \ circ } \ ) is tested in a triaxial cell under drained condition. The sand sample is also densified to a dense state...

Q:

Introduction On a construction site, it is proposed to excavate the existing ground to build a basement level car park. The cut slope in the excavation area will be vertical and will need to be...

Q:

( a ) Drained triaxial compression tests are carried out on loose and dense samples of a clean sand. The critical state friction angle ( \ ( \ phi _ { c ^ { 3 } } \ ) ) of \ ( 2 7 ^ { \ circ } \ ) is...

Q:

( T ) ( 9 ) The average degree of consolidation at any time t is defined as the ratio of settlement of the whole soil layer at any time and the ultimate settlement of the layer from primary...

Q:

1 . The behavior of loose sand in drained triaxial compression differs from that of dense sand in drained triaxial compression. ( i ) Sketch their deviator stress versus axial strain responses. Label...

Q:

The Direct Shear test results are shown in the Figure 3 below for one dense sample and one loose sample. The vertical stress applied in both tests were v ' = 3 0 0 kPa. The cross - section o the...

Q:

Which one of the two samples: sample A ( loose sand ) or B ( dense sand ) will exhibitgreater peak strength from a consolidated drained test ( i . e . , CD ) test on sand ) : Sample A ( loose sand )...

Q:

Q#4: Define Direct shear test, and explain separately figure 2 in detail given Below Expansion Compression Dense sand/OC Clay Shear displacement Peak shear strength Shear stress T Shear stress (kN/m)...

Q:

Which one of the following sandy soils ( shown in Figure l below ) ; Sand A or Sand Bwill have a higher saturated coefficient of permeability. Give reasons,Sand A 4 Sand B 2 Which one of the two...

Q:

( 4 ) In a CBR test, the following data was collected and tabulated as follows. What is the CBR for this soil? ( 5 ) A CU triaxial compression test was conducted on a saturated clay sample with a...

Q:

Calculate the maturity value of a $1000 face value, five-month note dated December 31, 2011, and bearing interest at 9.5%.

Q:

Explain what can be said about det A if: (a) A2 = I (b) PA = P and P is invertible (c) A = -AT and A is n n

Q:

BBA Comprehensive Exam Business Finance - Balance Sheets and Financial Statements The performance review of a business must compare against A an appropriate standard for comparison B ther porformence...

Q:

Information related to Crane Co. is presented below. 1. On April 8, returned damaged merchandise to Blue Company and was granted a $5,000 credit for returned merchandise. 2. On April 15, paid the...