Question: how to make setup this addressing table based on the question (e) using ACL command using CLI after doing the router ospf for R1 and
how to make setup this addressing table based on the question (e) using ACL command using CLI after doing the router ospf for R1 and R2


Table 1: Addressing Table (e) Setup ACL on the router interfaces and direction based on the following policies i. Permit packets from S1 going to LAN 1 (2 marks) ii. Deny packets from S2 going to LAN 1 (2 marks) iii. Permit packets from S2 going to LAN2 (2 marks) iv. Deny packets from S1 going to LAN2 (2 marks)
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
